Electronics Forum | Tue Nov 02 15:31:12 EDT 2010 | clarence
We are in need of a complete set of manuals (Originals or photocopy) for our Camalot 1818 machine. Willing to pay a reasonable price for these manuals. Please respond if you are able to assist us.
Electronics Forum | Tue Nov 08 04:11:34 EST 2005 | Eric C
I am trying to find out if there is any solvent for underfill material that has hardened/cured. Regular/routine maintenance of our dispenser units requires thorough cleaning oftentimes scraping is done for material that has hardened. Any inputs would
Electronics Forum | Wed Nov 24 11:43:42 EST 2010 | ettaco
Let me know if you still need help locating 1818 manuals. contact: equipment@ettaco.com
Electronics Forum | Thu Sep 10 17:13:31 EDT 2015 | tombstonesmt
There are factors that manufacturers have taken into consideration when dealing with coating. On/off times, dispense speeds, heights, etc.. Dedicated software with tools to easily map out paths are a godsend. We made our own coating machine with a s
Electronics Forum | Fri Sep 11 12:08:10 EDT 2015 | derrikf
I built one using an old Asymtek Automove. When all was said and done, it cost less than $400, including what was paid for the machine itself. It's a very basic setup, (air over syringe), but for our needs it does everything and more. With air to syr
Electronics Forum | Mon Mar 03 09:57:26 EST 2003 | msivigny
Hello markt, If you're only running at 85%, you've got some things to look into! First, it's good you know that you're operating at 85% with some measurables that help you determine that. Now, the easiest methodical way to improve productivity on SMT
Electronics Forum | Tue Nov 14 16:06:27 EST 2000 | zorox
We have an ERSA machine here where we have solder "spikes" occasionally. We have made sure our flux is dispensing properly, we have adjusted z axis speeds, our preheater is heating properly, adjusted XY speeds, etc. Can anyone think of something we m
Electronics Forum | Tue Jun 08 17:31:15 EDT 2010 | whitewing
For protos and very short runs I already use a polyester stencil + pizza oven process which is fine except for the placement time and tedium. I'm partly trying to bridge the gap between that and stuff that needs subbing out due to quantity, and partl
Electronics Forum | Fri Jun 04 11:54:22 EDT 2021 | cbart
We do this quote often with our older Summit machine. there are a few ways to do this. all of these are assuming you have parts on the boards already and are working around them. 1- if you have a good tech that can add solder to the pads on the PCB a
Electronics Forum | Sun Jun 06 12:51:34 EDT 2010 | whitewing
Hi - I'm looking into possible low-end pick/place machines (in UK) for prototype/small runs - taking the next step from plastic stencil/hand place/pizza oven, as my local subcontractors can't offer the fast turnrounds I often need for short runs. Bud
