Electronics Forum | Mon May 16 13:15:16 EDT 2022 | richardcargill
The camera crashing is usually a fault with the encoder on the Y motor assembly. someething to do with not finding a home pulse I think. Anyway, replace the motor/encoder and recalibrate and you should be good to go
Electronics Forum | Wed Mar 26 19:00:48 EDT 2008 | darby
Also check your belts/tensions/pulleys and motors on the camera axis. If you are getting any slippage then the camera will not be in the position the encoder says it is. It may still read the fids but will produce an offset.
Electronics Forum | Tue Mar 30 06:27:22 EDT 2010 | ristikas
It happens on the middle of the stecil cleaning. The camera and the cleaner will stay under stencil in half way back. Then machine asking the initate the motors. If to press initate then the pcb stopper will hit the rails. Usually we move camera and
Electronics Forum | Fri Feb 03 12:25:34 EST 2012 | cyber_wolf
The camera is probably clipping the top of your board when it is reading fids. This causes the motor to lose steps. Manually load a board to vision height and drive the camera over the board to check for clearance issues.
Electronics Forum | Mon Jun 11 11:07:04 EDT 2012 | wbtimms
take a look at http://www.tri.com.tw linear motors side cameras 3 ccd camera technology
Electronics Forum | Fri May 20 12:14:25 EDT 2016 | strandy89
Im having trouble with and Ekra x5 machine. It works fine when up being run constantly, but if it sits for 10-15 minutes when you try to move the Y table to the front of the machine it makes a loud sound as if the table is hitting/catching on somethi
Electronics Forum | Wed Feb 08 01:30:02 EST 2017 | nikkilouie
Im having trouble with and Ekra x5 machine. It > works fine when up being run constantly, but if > it sits for 10-15 minutes when you try to move > the Y table to the front of the machine it makes > a loud sound as if the table is hitting/catchin
Electronics Forum | Sat Mar 25 16:01:08 EST 2006 | gipos
Dear all, Please help me to find out where we can find a Z axis camera motor for Panasert SPP A- M (NM 2624F)paste printer ?? Thank you Mike ZIG
Electronics Forum | Thu Jul 27 22:27:45 EDT 2006 | seth
Vision X-Y maintenance procedure, please advise. I have problem with camera not park so often time, and I don't have any solution accept buying a new vision Y right stepper motor, but that's just too much money roughly 2500 dollars.
Electronics Forum | Thu Oct 02 01:59:06 EDT 2008 | edmaya33
Obviously nobody can help you Jack. 1. its the camera for parts recognition ( enhanced CMOS ). 2. positioning system upgraded from ball screw to linear motor/gantry. before CPH=16500 new CPH=18000 using H12S