Electronics Forum | Wed Apr 07 11:36:41 EDT 2004 | stefwitt
Your machine will have to have a reference position. From this reference position, you determine all other machine positions. If the camera is attached to the head, you could place a glass slug and measure camera-nozzle offset, by placing the slug w
Electronics Forum | Thu Apr 08 23:08:56 EDT 2004 | Ken
Well, the precision glass is for upward looking camera's. It essentially is a "perfect part". Vapor deposition lithography on glass (for Cte stability)....basically the part pattern (or part fids) is compared to its target location (same pattern on
Electronics Forum | Wed Apr 07 21:49:44 EDT 2004 | Ken
My favorite kind of calibration is where the machine learns what it did incorrectly. Then fixes itself! However, there are many types of machines that rely on human feedback as to the results of what it did. nozzle calibrations involve many factors
Electronics Forum | Mon Jun 18 11:15:53 EDT 2001 | Gil Zweig
The cost of an x-ray inspection system will be determined by the following inter-related paramers: 1. The focal spot size of the x-ray source. 2. The maximum tube voltage. 3. The physical size and shielding requirements of the systems. 4. The design
Electronics Forum | Sat Nov 07 14:05:43 EST 2009 | doremi
Hi, I have 4 years as an AOI Process Engineer and we are working with 3 types of AOI - Marantz 22X, VI3000 and Omron (RNS & VT-WIN2). For solder joint inspection (solder meniscus quality, insufficient solder, wetting problems, shorts (bridges) Omron
Electronics Forum | Fri Apr 08 07:55:14 EDT 2005 | CN
Sounds like it would by tough to justify, thought of oursourcing? if the volume is really that low I bet it would be cheaper to find an outside source to build them for you. As far as hand placment accuracy If you are hand placing BGA's or even worse
Electronics Forum | Tue Aug 04 11:10:22 EDT 1998 | Chrys
| Hi Stoney, | Justin is giving you some good advice, unfortunately these kinda' problems sometimes call for the ol' D.O.E...otherwise, you could be chasing your tail for a while until you figure out exactly what's causing your problems. | Has
Electronics Forum | Thu Oct 22 15:18:07 EDT 2020 | jaguar
I have two ESI-650F vision cards and both have the symptom's that of not recognising the Cameras. Is there any UIC users that had similar issues?
Electronics Forum | Wed Apr 11 14:57:31 EDT 2007 | itwasbill
Hi all! We are placing BGA's using a QSV-1 pck and place machine. I believe our profile has the correct information but we continue to get vision results not available when we inspect the part. Our screen appears as follows: NO RESULTS AVAILABLE PAR
Electronics Forum | Thu Apr 11 10:17:17 EDT 2013 | ericrr
Some times the PCB manufacture sends PCB panels with bad circuits, there are three ways to make these PCB without placing parts on the bad circuit, Well two in fact plus my method. (1) Placing a light mark on a dark background (or reverse) then the
