Electronics Forum | Thu Dec 01 16:11:03 EST 2011 | cowens
I have a MPM UP2000. When running or after teaching fiducials you will here a clank and the error "Camera not parked" will show. If anyone has experienced this on have any suggestions plaese advise. Thank you.
Electronics Forum | Sat Jan 09 20:00:04 EST 2021 | oxygensmd
I had similar issue on S20 two times. The portal2/gantry2 have camera image? Have working camera system - if other camera ok, PCB camera will be the problem. Have camera screen on BE/Components camera? Have iCOS PC working. - Check the camera conn
Electronics Forum | Thu Jan 07 03:32:19 EST 2021 | ravikumargv
Dear All, In S27HM siplace machine PCB camera images not display and when i try to teach feeder potion or fiducial position PCB camera light is glowing but, images not showing in monitor, kindly help what is the root cause for this issues... Regard
Electronics Forum | Thu Jan 07 03:34:24 EST 2021 | ravikumargv
Attached Image FYR....
Electronics Forum | Tue Jan 05 21:28:18 EST 2021 | rmitchell
We have an old MPM accuflex and both camera lights stopped working this morning during production. We tried the bulbs but the new ones did not work either. Any ideas on this? I don't think we have a manual but will keep looking in the dungeon. Plea
Electronics Forum | Mon Jan 11 17:19:31 EST 2021 | rmitchell
Problem resolved- The machine camera had crashed when the operator put the PCB in upside down (this was kept secret until intense water boarding). The crash seem to take out a chip on the vision processing PCB. It was visually damaged and looked lik
Electronics Forum | Wed Jan 06 22:10:04 EST 2021 | emeto
Measure if you have power where the light should go. Don't remember but it is probably 5V bulb/12V buld(it should say on it). if you have power, measure the bulb. I am not sure how new you new bulbs are.
Electronics Forum | Tue Dec 09 11:40:38 EST 2008 | dwl
Hello, I have an MPM AP 25 and the camera parks itself over the worknest, so when the z tower tries to rise to print, it collides with the camera. Is there some way to adjust the park position so that the camera in not in the way of the Z tower? Than
Electronics Forum | Mon Sep 02 15:20:48 EDT 2013 | aemery
Interesting! not the usual error. In my experience when the vision cables get damaged it shows up and white noise flashes across the monitor. The connections are the easiest to check so here's your system layout with connection points. Starting at
Electronics Forum | Mon Feb 22 15:44:42 EST 2010 | remullis
Just bought a used machine and everything was working fine and now the camera will not initialize. Powered down completely and rebooted, same thing. I powered down again moved camera to center of axis, it moves to the lower right hand corner which I