Electronics Forum | Tue Aug 01 18:12:18 EDT 2006 | SWAG
Check to make sure the platen and the camera are meeting the sensors that tell the machine they are "parked". Find these sensors and flag them. Look for indication they are working in the input screen. Also, make sure the sensor flags can go into
Electronics Forum | Tue Mar 28 19:28:54 EDT 2017 | aemery
Giao, These style of MPM's use stepper motors, but no feedback like an encoder or a resolver. In other words all axis positions are assumed after "Reset" of the machine. Because of this style of drive system there is the potential for the vision ga
Electronics Forum | Fri Jan 05 10:58:43 EST 2018 | ilavu
John, I just found out more detail. If my board stop position in x is bigger than 109mm, I get error from park position to board stop.This problem started after power loss. The error comes up system power down and after pressing system button "RISIN
Electronics Forum | Mon Aug 20 05:45:18 EDT 2012 | bobpan
To solve your problem....you should do the following: 1. Super Lube the o-rings on the z-rod bellows. 2. Make sure your head to camera calibration and head to head calibration is good. 3. Line up the nozzle changer pocket positions. 4. Make sure you
Electronics Forum | Mon Aug 13 12:18:56 EDT 2007 | swag
Our UCT runs on windows. I like to use UPS then drop that program on the machine then save it to UCT after it's running well. I guess mostly because I'm used to UPS/uploading CAD data. However, if you use UPS in combo with UCT you must be sure to
Electronics Forum | Sat Jul 16 18:24:11 EDT 2016 | aemery
Scratches do not necessarily mean bad! Usually the forcer motor fails before a platen. The motors become weak or don't evenly distribute the supplied air, which causes them to tilt and drive into the platens. Mechanical misalignment of the VY forcer
Electronics Forum | Wed Aug 10 09:56:09 EDT 2022 | jojoled
Hi guys, from certain time (not sure, but it could be power down last week) none of the 2 heads can succesfully pickup nozzle from ATC (after startup calibration is done, but in the calibration sequence the ATC height is not measured, it just calibra
