Electronics Forum | Wed Jan 24 21:29:43 EST 2007 | davef
Board fabricators commonly use Barco AOI to inspect film. The AccuMatch compares pixel-to-pixel of the Gerber data to the image seen by the AOI camera. It's slower than design rule checking, but has definite advantages [like lower falsing]. Unfortu
Electronics Forum | Fri Apr 02 04:02:18 EDT 2010 | manju2cool
Hi, I think concept of inspection through AOI is changing. I am struck in confusion.Because some manufacturer say 3D inspection, with 1+4 cameras is ultimate solution. Orbotech also came with 13 cameras at once!Now some say, all these are eyewashing
Electronics Forum | Tue Mar 30 05:03:56 EDT 2010 | markslade
Thanks for your help. mark.
Electronics Forum | Tue Mar 16 11:39:13 EDT 2010 | markslade
I have a mirtec MV-3L, does any one know, when drawing a component part with varios side angle camera views can i group that part and its camera views to save in the library and if so how?
Electronics Forum | Fri Apr 02 10:26:13 EDT 2010 | fishingfool
Manjunath The top camera will be used for probably 90-95% of your inspection needs. However, without side cameras that 5-10% of uninspected parts can be a real pain to manually verify. What you need to figure out is what is your product to inspe
Electronics Forum | Mon Mar 29 10:20:29 EDT 2010 | CL
Good Morning Mark, I do not believe that you can group images from multiple cameras. You can save a camera image into the library but you would need to re-name the part number for the side camera if you have an image from the downward looking camera
Electronics Forum | Sun Sep 25 20:20:22 EDT 2011 | johnyq
We recently aquired an old MPM-AP25 stencil printer that printed paste with a large error (about .060 inches). I concluded camera alignment to be the cause but was surprised by the magnitude. I found the camera beam splitter prism misaligned and loos
Electronics Forum | Fri Aug 27 07:46:47 EDT 2021 | compit
No. "The target position is outside the moving area".
Electronics Forum | Thu Aug 26 20:35:33 EDT 2021 | kumarb
Hi. Have the Emerald-X (Yamaha YV88X) unit. Works fine. Using F9 (Teach & Trace), we can position to most locations on the front feeders (not to the extreme left or extreme right due to the head design). Should the unit be able to do the same for t
Electronics Forum | Sat Aug 28 13:20:08 EDT 2021 | kumarb
Thanks Michal. Will need to do more homework for our next machine. Considering the YSM10 or YSM20 but only once we fully understand the features and shortcomings of each.
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
