Electronics Forum | Fri Sep 26 16:02:28 EDT 2014 | heath
Hello all, I'm curious to hear how successful others have been with vibration feeders on their pick and place machines. We have a MY12 and a major source of consternation comes from parts not shaking down to where they can be picked up. The variab
Electronics Forum | Sat Sep 27 19:47:21 EDT 2014 | cyle
Reels are 100% the best, vibration feeders should always be a back up, they are quite unreliable through no fault of their own. Say you have 1000 parts to be placed, and the cost of a reel is 100$ more than a tube, but the reel loads 10 to 1 over th
Electronics Forum | Mon Sep 29 18:37:22 EDT 2014 | spoiltforchoice
Don't know if you can do it on a MyData, but I have found that I lower the rate of failed pickups on our machine by altering the placement order of devices. Specifically insisting it does not attempt to pick sequential parts from the same lane. Of co
Electronics Forum | Wed Oct 01 07:22:11 EDT 2014 | oguzdtas
First all, I am very new about all this stuff so please forgive me if i say anything wrong. We are using a universal vcd axial. We had a problem with cut and clinch. We blieve if we lengthen the wreck material going inside the tubes, the problem wil
Electronics Forum | Wed Oct 01 15:24:55 EDT 2014 | horchak
are you trying to lengthen or shorten the lead length? Lengthening the amount of lead being cut off and going into the scrap tube will shorten the lead length. Lead length is pretty much determined by the down stop setting on the insertion head, the
Electronics Forum | Thu Oct 30 23:39:10 EDT 2014 | beilimanu
No paper thing, while I can make some suggestions based on my experience. what is the size of your via? If it's smaller than dia0.4mm, in PCB production process it should be filled by soldermask. So my suggestion is design it to be full filled by SM
Electronics Forum | Thu Oct 09 17:37:58 EDT 2014 | rgduval
Got a failure while starting up our GSM, and hoping you guys have an easy fix that we're not seeing. We're getting a Timeout waiting for nozzle changer vacuum buildup. It seems to be occurring on head 2, during nozzle change. We've reseated all of
Electronics Forum | Tue Oct 14 09:20:04 EDT 2014 | rgduval
Thanks, Deni, I discovered the servo control box, but, noticed that it was a sealed unit (and a third party unit, at that)! I wasn't sure if I should muck about with digging into it. But...now that you've identified the driver slots for me, we mig
Electronics Forum | Tue Oct 14 11:45:19 EDT 2014 | tombstonesmt
Scan Reel> THEN Verification system requires scan of reels directly to the right and left previously performed verification. Maybe even a timer to allow splice. It's difficult to achieve successful training when an operator is constantly told what t
Electronics Forum | Tue Oct 14 09:17:09 EDT 2014 | rgduval
You could check the data sheets/web sites from the manufacturers of the press-fit parts. They typically will identify the recommended tooling/equipment necessary to install their components. Generally, pneumatic presses are suggested, with controll