Electronics Forum | Sun Dec 04 15:48:25 EST 2011 | ngineer
I would like to get some parts for my Quad IVc, but it seems the prices of feeder bases / feeders / vib feeders are more than the machine cost me, so I was wondering if anyone on here had extra or spare parts that they would like to part with. I'm g
Electronics Forum | Sat Dec 17 16:46:45 EST 2011 | eadthem
Startup current depends on your configuration. ours dose zones 1,2/ 3,4/ 5/ 6,7 last i checked it pulled about 40-55 ish on start up and 25-35 during run. our profile is a slow ramp till 170c then a fast ramp to 285c 280c(last 2 zones). 1707's
Electronics Forum | Wed Dec 07 17:43:31 EST 2011 | mikenil
Hi I do not work for a board house but a manufacturing facility where we do a considerable amount of soldering wires to through holes. We pretin our through holes on both sides of the PCB prior to reflowing the solder and installing the conductor (w
Electronics Forum | Tue Jan 03 13:44:18 EST 2012 | daxman
Hi comando, If you change a camera, there are quite a lot of calibrations you need to carry out. Firstly: Did you remove the camera from the mounting bracket? If so, you'll need a special jig to mount it back on the bracket properly. You can still d
Electronics Forum | Fri Mar 09 04:10:18 EST 2012 | grahamcooper22
Hi, I've been supplying Totech dry cabinets in the Uk for 10 years and in that time I've realised the only places to find the correct MSL level is on the dry pack the devices are shipped in or by spending hours on the internet or speaking to the devi
Electronics Forum | Wed Jan 11 18:10:26 EST 2012 | davef
New Webinar on Laser Depaneling SMTA Webinars On February 9th, Josh Brown of LPKF Laser & Electronics will walk you through the advantages and disadvantages of laser depaneling in comparison to more traditional methods of depaneling such as routing,
Electronics Forum | Tue Jan 10 19:01:13 EST 2012 | carvincorp
I was wondering if anyone else out there using the Vectorguard system by DEK has had problems with leaking air bladders. We started using a 29 x 29 frame about a year ago, and already, we've needed to send the frame back 3 times for repair due to int
Electronics Forum | Wed Feb 15 10:37:19 EST 2012 | caerleon
The only way you will be able to measure it is to count the reel before you put it on the machine, count them when they come off and deduct the amount expected to be placed. you will then have the result of attrition on the machine. or.. Pick the p
Electronics Forum | Fri Feb 17 11:48:25 EST 2012 | davef
Here's a link to an earlier thread on SMTnet that may add something to the conversation http://www.smtnet.com/Forums/Index.cfm?CFApp=1&Message_ID=20871 Allowing fabricators to X-Out boards is a bad idea. * X-Outs are randomly placed * Machines can
Electronics Forum | Tue Feb 21 16:38:18 EST 2012 | comatose
We finally can't avoid adding wave solder to our process anymore. For lead-free, medium sized wave I'm leaning towards mid 2000s senju units as the best fit. I've never run their equipment. Opinions? As a point of reference for our general capabilit
