Electronics Forum | Thu Sep 04 05:18:45 EDT 2014 | sasa29
PCB Manufacturing demands preparation of design well in advance. The finalized designs are fed into the systems and the production is carried away. If the boards are of small sizes, multiple boards are made on a single large board and separated into
Electronics Forum | Tue Sep 16 13:43:48 EDT 2014 | gascon5383
We have new stencils produced every 15000 prints. Another technician takes care of that and he uses gerber files to have them produced. Also, we have over 300 different products that are produced, all board sizes are standardized 287mm long x either
Electronics Forum | Mon Sep 15 23:59:09 EDT 2014 | marcelorotofrance
Hi evreybody I wish to know if somebody can describe how is made a "Calibration Slug" for centering the upward camera of a QUAD IVC machine. The instruction manual mentions a slug that is attached with vacuum to the "Vision Nozzle" and there is some
Electronics Forum | Wed Sep 24 09:53:25 EDT 2014 | rgduval
For me, it would depend on a couple of things: 1. How many parts are stored in this manner on a regular basis? 2. Was the oven used for anything else other than this type of storage? If it was a low volume of parts, and the oven wasn't used for
Electronics Forum | Mon Sep 29 16:20:08 EDT 2014 | rgduval
Our success rates with MyData vibe feeder were always tentative. Sometimes you'd get it to go great, sometimes, not so much. MyData allows you to control frequency and amplitude on the vibration. Trying various combinations of the two was key to g
Electronics Forum | Mon Oct 13 08:43:56 EDT 2014 | rob
Hi Larry, Picture a old lady with a set of knitting needles with leads attached to them, pressing the needles into different points of the PCB (pads, test points or component leads) and measuring resistance, inductance, waveforms etc between these p
Electronics Forum | Mon Oct 13 16:32:55 EDT 2014 | tombstonesmt
Designator>Part Number>Alternate. 2D labels are placed on all slots of the machine, operator scans slot, scans reel with unique material ID. Green light if it's good, red light if it's bad. Our software cannot lock out a machine if there is an incorr
Electronics Forum | Wed Feb 18 13:32:58 EST 2015 | stevea
Hi Rob, Not sure if you made any decision on your SPI requirements. The recently established VisionMaster (Long history of previously shuttered business names) company sells products similar too, but not the same as the past "VisionMaster branded" p
Electronics Forum | Mon Nov 10 09:11:51 EST 2014 | rgduval
The centering jaws are made out of copper, I believe...and conductive. I'd suggest that the conductivity of the copper makes it a fairly poor source of ESD damage in a component. I have observed physical damage to components from the centering jaws
Electronics Forum | Fri Nov 07 14:30:32 EST 2014 | klopi90
Hello! I am a lucky user of an ALD515 AOI, a cheap Chinese machine, and I would like to aks if anybody has any experience with it? My main problem is a lack of any manuals or tutorials for learning, what cause other difficulties. I have a one main
