Electronics Forum | Mon Jan 28 07:40:40 EST 2002 | cnotebaert
Yes and Yes, Your solder supplier should recomend a profile (standard profile) in most cases you can follow it. Of course you should be running a thermal profile of each board type to verify it is within the specified temp rang. You should also chec
Electronics Forum | Wed Jan 05 10:55:12 EST 2005 | OverTheHill
WOW Sr.Tech, 40K worth of bent tools? I'm about ready to be sh*t canned because of 1K's worth. As for trimming the mags, the product is running fine (many boards) and then out of nowhere the tool bends, so I assume my PERFECT operators trimmed the ma
Electronics Forum | Wed Jan 05 09:24:53 EST 2005 | cyber_wolf
Well...here is what I can tell you: I have over $40K worth of bent A12,A13,A14 tools.Yes you heard me right $40K worth. (Since 1995) Mydata used to make a repair kit to fix them but decided to quit. They tell me the reason they quit making the kit i
Electronics Forum | Tue Jan 31 14:30:38 EST 2006 | Chunks
There is none, since we don't know your part or temp being used. A heat gun CAN be used to remove parts with no damage, if its controled. You need to look up your part on the manufacturers web site, find the process data (time/temp)the part is desi
Electronics Forum | Tue Jan 31 15:15:13 EST 2006 | russ
Heat guns used improperly will definitely damage components. You must have a controlled heat gun that can be set to the max temp you want pb =215C max, Pbfree maybe 240C max. This heat gun must not be able to be adjusted or you must have total trus
Electronics Forum | Tue Jan 31 15:51:04 EST 2006 | russ
Relays huh? I can tell you from previous experience that relays are not a good heat gun candidate. Did you check how long this part can withstand the 240? I do not know what the 4 setting is on a liester but it is probably well in excess of the 24
Electronics Forum | Tue Jul 17 11:15:05 EDT 2007 | allgood
We keep seeing a problem with the plastic tool tip on an A12 tool being sliced off. I think it is hitting the edge of the tape separator clip assembly - I determined this by coating the tip in paint and then finding where the tip had struck the meta
Electronics Forum | Wed Jun 27 11:58:42 EDT 2012 | cyber_wolf
Your tool tips are being damaged because the small x-motor is not engaging when the head is picking parts. When this happens the head overshoots and you bang the tips on the mag springs. Directly after a tip gets damaged go into the service program a
Electronics Forum | Tue Nov 25 11:58:31 EST 2008 | rway
Hello all, We are using z1850/60 machines. The APC test is damaging a 1.8V device on the board. The APC stimulates -/+3Vdc in fast mode. I understand the dangers of over-voltage. But what I need to know is how the part is being damaged when the ent
Electronics Forum | Mon Mar 01 13:08:07 EST 2021 | astarotf
Hello This part of the machine was damaged and we still cannot contact a supplier that sells it. If anyone has any contact that can provide me with spare parts for the GSM2 dual beam machine (4688A), I would appreciate it. Or if someone can provide
