Electronics Forum | Thu May 30 10:31:03 EDT 2002 | robbied
Hi Yannick. This is an issue that we are just recently getting into but here is some ifo that I have gathered so far. I have seen/ used 2 different rework machines. The one we have bought is a 'PACE TF2000' which was at the lower cost end of the mar
Electronics Forum | Sun Apr 16 14:37:25 EDT 2000 | Roberto Navarro
Hi, I work for Nortel and here rework BGA'S we use DRS22 rework station and CRT 2000 X-ray inspection. The main problem is put again the BGA on the PCB because you need reboling the PCB and you could damage the soldermask. Talking about Air-vac is ve
Electronics Forum | Fri May 01 14:54:12 EDT 2020 | capse
Disclaimer, I'm a VJ Electronic Rep. The VJ Electronix XQuik II is an x-ray parts counter. You can load a PCBA into the system and capture an x-ray image. The system has zoom functionality. But, you will not get the type of measurement and inspection
Electronics Forum | Mon Nov 19 09:51:51 EST 2001 | MDion
Bonjour, Is there any study done about the effects of X-RAYs (INCLUDING Airports/Customs systems) on electronic assembly ?? We have had few problems with products recently where the programmed flash was not functionnal (corrupted data) when tested
Electronics Forum | Tue Mar 19 07:24:17 EDT 2024 | aglucky
Common Reasons and Solutions for a Non-Functioning Ice Maker As one of the most frequently used and common household appliances. Our ice maker can provide refreshing food, drinks, and fast and stable service. However, in our daily lives, ice makers m
Electronics Forum | Mon Feb 18 17:27:03 EST 2002 | hgwells
Agilent has a great article on determining whether automated optical inspection (AOI) or automated x-ray inspection (AXI) is right for you. It's a PDF file that can found here: http://www.ate.agilent.com/EMT/LIBRARY/X-RAY/DOCS/59883661en.pdf To sum
Electronics Forum | Mon Jun 18 19:57:40 EDT 2001 | Gil Zweig
Dave: You pose a very good question. We have been in the electronics x-ray inspection business for 18-1/2 years and, to date, we have not received a single report of damage associated with x-ray exposure. However... we do see signs of long term x-ra
Electronics Forum | Fri Feb 09 13:05:14 EST 2007 | realchunks
Lawyer questions in the fact that they are silly or seem so vague? "1. Can X-Ray Inspection System damage the EPROM OR OTP during inspection after Reflow?" No, not by typical X-ray equipment designed for PCB manufacturing. "2. At 300 degree Ce
Electronics Forum | Tue Feb 09 23:40:19 EST 2010 | glennster
OK Sergey, looks like no one wants to take this on. I will give it a shot and maybe others will add their 2 cents. The answer depends on what you want to inspect. X-ray inspection is based on the X-ray absorption properties of the materials in th
Electronics Forum | Mon Jun 18 18:13:22 EDT 2001 | davef
Would comment extensively on the following? The xray equipment vendors have told me that xray tubes that are less than 100kV have a very low probability of damaging components. Note the "very low probability" statement - they have not seen any custo
Our Company handle AOI (Auto Optical Inspection) and SPI (Solder Paste Inspection) Machines.
Equipment Dealer / Broker / Auctions
Hwaseong-si, Gyeonggi-do, Korea
Hwaseong-si, South Korea
Phone: +82-1029254936