Electronics Forum | Fri Feb 12 02:49:12 EST 2010 | smellew
CC if this works good, MCS & F4G cables are different also different to the Host cable i gave you before. do you have setup manuals? regards llew
Electronics Forum | Fri Feb 12 12:58:42 EST 2010 | smellew
CC is a must. IIS must be installed & setup on windows regards Llew
Electronics Forum | Thu Feb 11 18:51:49 EST 2010 | rodrigo
Hi All, I'm setting up the F4G software for our line (currently using MCS30). I made an adapter to connect the CP4 line (that was connected to the MCS30) to the PC. Then I tried to transmit a program but I keep getting this error: 41A27F9D: Error o
Electronics Forum | Fri Feb 12 12:19:28 EST 2010 | rodrigo
What do you mean by "check if F4G is connecting to CC...". The CC DOS windows shows up when I login the PC so does the remote shell daemon. The CC DOS windows says a bunch of stuff does has been woken. I didn't install the FTP stuff. I didn't think I
Electronics Forum | Fri Feb 12 19:40:42 EST 2010 | rodrigo
I posted the message below on Friday and today Monday I started looking at the problem again. We have a computer with a setup that works. It is the original PC we bought with the F4G but it is set up for a machine we do now have ,IP3. I was looking a
Electronics Forum | Fri Apr 27 10:52:16 EDT 2018 | dszewczak
Awesome. Thank you!
Electronics Forum | Tue Dec 07 00:13:00 EST 2004 | saiwong
I have a problem that our JOT convoyors & loader cannot connect the Fuji machine. Also, I wondered how can I get the support from JOT.
Electronics Forum | Thu Nov 07 10:07:02 EST 2019 | charliedci
Requesting help from anyone with experience in reflowing Te Connect, PN 1565917-4, 200 pin connecter. Pic attached. Cannot get all 200 pins to wet, main suspect is slight PCB warping during reflow. Have adjusted reflow profile. A 2.75 inch long SMT c
Electronics Forum | Tue Nov 15 16:16:36 EST 2005 | bk
When it prompts for the save staus and reboots does it keep rebooting over and over? And does it come up with the error message cannot connect to MYSERV?
Electronics Forum | Tue Jan 24 20:05:24 EST 2017 | erici
we have one dot matrix printer and i would like to connect it to the TP9 machine. The parameters settings for printer is "protected" so i cannot assign the printere to the machine. How do i "unprotect" the parameter to allow me to make changes?
