Electronics Forum | Fri Sep 26 12:16:52 EDT 2008 | bickt
you cannot swap 0-3 only 0-1 or 2-3 they are not the same euro cards. they function very diffrently. if you look you will see there are more chips and circuitry on one set. there are 2 w/red leds and 2 with green leds. at least thats how they soo
Electronics Forum | Thu Sep 04 09:40:14 EDT 2014 | rgduval
I'm surprised MyData is pushing the service call. They're usually pretty good at walking you through some troubleshooting steps before going straight to the service call. So, the failure sounds like an encoder failure; the encoders are attached to
Electronics Forum | Fri Nov 12 15:56:50 EST 2004 | pdeuel
Thanks, That's the direction i'm headed. After by passing relay altogeather, testing large caps for the driver supply, replacing bridge rectifiers, and the MOV's, that's about all im left with. The vacuum motor will run with the software toggle witho
Electronics Forum | Thu Mar 15 13:39:06 EDT 2018 | gregp
Impact is the instantaneous force at the time the component first reaches the PCB. F=M*a....so the acceleration is the key factor. If charted on a graph it would look like a spike...higher force for a short duration. The placement force is typical
Electronics Forum | Thu May 03 22:51:14 EDT 2007 | jmelson
I am still learning the CSM84, but have gotten one board programmed and working. Now, I'm doing the next board, and need to use the mechanical alignment unit for a 22 x 22 mm TQFP. This chip is too large to clear the jaws on any head. Can the CSM h
Electronics Forum | Mon Feb 26 06:23:38 EST 2001 | johnwatt
Folk's, I've been running with the datapaq system for about 5 years now. I have been using it on both reflow and on wave, the only issue I've ever found is that you cannot predict settings for wave, but then you can't do that on Kic and I don't thin
Electronics Forum | Wed Mar 10 21:56:40 EST 1999 | Dean
| For Dean and the rest of you interested, | | I have reconciled many of my thermal issues with this machine and its peculiarities. The bottom side heater seems adequate, at 750 watts (not going to spend 10 grand extra for 500 more watts no matter w
Electronics Forum | Thu Mar 11 16:44:34 EST 1999 | Earl Moon
| | For Dean and the rest of you interested, | | | | I have reconciled many of my thermal issues with this machine and its peculiarities. The bottom side heater seems adequate, at 750 watts (not going to spend 10 grand extra for 500 more watts no ma
| 1 |
