Electronics Forum | Tue Jul 05 11:50:52 EDT 2016 | emeto
Depending on the Capacitors I will wait at least 15 seconds to be safe.
Electronics Forum | Sun Apr 11 20:03:46 EDT 2004 | Tom B.
You should add a Capacitor Discharge statement in ICT test Software. This could be done by selecting the nodes and have statements to connect relays to ground. Could be possible that the Selective Soldering system is the cause, as problems is now s
Electronics Forum | Sun Apr 04 10:16:16 EDT 2004 | cyclopsn
I'm involved in backplane manufacturing process. There are about 10 electrolitic capacitor assembled in my board.These capacitor are soldered using a selective soldering machine. My problem is that these capacitor will charged up and failed as short
Electronics Forum | Thu Jul 16 05:15:37 EDT 2009 | discovery747
Foreword 2009-07-16: This information was /is posted at http://www.discovery747.com/counter hosted by Yahoo Small Biz. Unfortunately yesterday for the first time in years this site was down. Today is up again, and I hope it stays that way. So in case
Electronics Forum | Wed Dec 13 11:24:08 EST 2000 | Wolfgang Busko
Hi George, bad luck! That�s why we professionals get so much money for it. Those "thingies" are mainly capacitors or resistors. If a capacitor is missing you might with luck not even notice it. A resistor, that�s different, you will notice it, what
Electronics Forum | Wed Dec 13 11:24:10 EST 2000 | Wolfgang Busko
Hi George, bad luck! That�s why we professionals get so much money for it. Those "thingies" are mainly capacitors or resistors. If a capacitor is missing you might with luck not even notice it. A resistor, that�s different, you will notice it, what
Electronics Forum | Thu Nov 20 03:58:39 EST 2014 | hhat
To get the best performance of electronic circuits, components and circuit board supports circuit components and devices in electronic products. Even if the circuit principle diagram design is correct, the printed circuit board is designed improperly
Electronics Forum | Thu Jul 13 22:20:38 EDT 2000 | Dave F
=10 mils larger than lead 3 silk screen legend text weight >=10 mils 4 pads >=15 mils larger than finished hole sizes 5 place through hole components on 50 mil grid 6 no silk screen legend text over vias (if vias not solder masked) or holes 7 so
| 1 |
