Electronics Forum | Sat Mar 31 08:47:24 EST 2001 | davef
Sure, researchers measure shear as an element of their material characterization process, but that does not make it an acceptance test. [Truly, this conversation is not uncommon on SMTnet. So, it would not surprise me if an enterprising something o
Electronics Forum | Fri Mar 30 18:24:12 EST 2001 | davef
There is no test. Beyond the issues that you mentioned that affect shear, an article published in a recent [1/01] "Journal Of Surface Mount Technology" documents that shear is also dependent on the rate of shear. You may be able to contact the auth
Electronics Forum | Fri Mar 30 13:06:50 EST 2001 | aortiz
Hi, I need support on the method or applicable standard to measure the shear force strength on chip capacitors and resistors. I know the soldered joints strength is related to land desing, solder volume, pcb and component solderability, component
Electronics Forum | Fri Mar 30 20:06:55 EST 2001 | aortiz
Maybe there's no test and I don't know where or why my customer came with that requirement (I think because in one of the board shipments he got a board were a smd resistor broke, but I think that happened because miss handling), but anyway I need so
Electronics Forum | Mon Jul 24 23:34:14 EDT 2000 | rzkr438
I am tyring to find out shear force requirement for BGA attached on board .I measured two group for shear force to check underfill process effectiveness on BGA .Two group showed siginificant force diferrence .I am very sure underfill process is effec
Electronics Forum | Tue Aug 21 17:36:13 EDT 2007 | mzmjv1
I wonder if there is a standard pull out force appliied to axial capacitor in manufacturing production line site
Electronics Forum | Tue Aug 21 20:52:06 EDT 2007 | davef
There is not standard for the force to pull an axial lead from a soldered connection. ".....IPC does not have pull tests in any of its standards, and some reliability experts would prefer to keep it that way, pull tests are commonly used by some lea
Electronics Forum | Tue May 23 20:39:37 EDT 2000 | Dave F
Scott: Sounds like fun: � Solder joint strength in pull/shear varies with lead geometry, solder volume, lead metal/metallization, and the test method. � Among things, IPC-TM-650 talks to getting pads off-of boards. For instance: Method 2.4.8 is for
Electronics Forum | Wed Jul 03 15:40:17 EDT 2013 | davef
Shear tests are [in my opinion] senseless. The shear stress you measure depends more on the shear rate and on the point where the force is applied than on the grain structure. When shearing a component, you not only apply shear stress, but also roll
Electronics Forum | Wed Apr 11 06:56:20 EDT 2001 | brownsj
Most of the component vendors I've dealt with will guarantee the solderability of the terminations for three years if the components are still packaged in a full reel. If the reel is part used we've kept them for 1 year and then used a wetting balanc
.gif)
