Electronics Forum | Fri Feb 21 10:03:43 EST 2003 | genny
Sure they'll do it...If you're willing to pay double or triple the cost. It might not be as easy as you think. the value is usually marked in white over the black carbon area that actually is the resistor. Underneath is just the white ceramic carr
Electronics Forum | Tue Jan 30 21:15:51 EST 2001 | davef
You seem to pretty far from shore to begin thinking about boats and floatation devices. Most laser trimmers are used by: * Semiconductor fabricators * Resistive component fabricators * Hybrid circuit assemblers Component fabricators and hybrid [
Electronics Forum | Thu May 13 19:41:17 EDT 2004 | johnww
Hi Everyone, I want to use LEDs in an enclosed box for edge lighting etched glass. There are 15 LEDs in a box and they are set up in 5 series of 3 LEDs. The LEDs are 3.5V 20Ma 8000mcd. I've worked out that I need an 82 ohm resistor for each series
Electronics Forum | Thu Jan 04 21:27:39 EST 2001 | John L.
Thanks for the reply Stevo...! I am looking at doing just that. I would really like to ID this component and repair this Pico board though... After several searches, I can't find any (3) element resistor or capacitor networks to match it. I'm hop
Electronics Forum | Wed Feb 25 08:34:00 EST 1998 | Earl Moon
CERAMIC CIRCUITRY Starting with hybrid thick film circuits in 1965 at Sperry Flight Systems, I have been involved with ceramics (usually aluminum oxide) as the substrate material. Then, we developed "multilayer" circuitry (replacing "cordwood" module
Electronics Forum | Wed Feb 25 08:30:44 EST 1998 | Earl Moon
| Happy Holidays All, | I am searching out a vendor (US preferred) who can fabricate a ceramic PCb with etremely fine lines. | Please reply if you are a vendor, or know of one. | Thanks, | Wendy CERAMIC CIRCUITRY Starting with hybrid thick film circ
| 1 |
