Electronics Forum | Thu Feb 06 04:58:04 EST 2014 | escalador
This is just what I was looking for.I dont have the manuals. Many thanks.
Electronics Forum | Tue Aug 12 09:17:22 EDT 2008 | bobpan
We used a photo-optic sensor powered off the conveyor after the oven that is tied to a relay that trips when a board is seen at the sensor which causes a buzzer to go off. Very simple to make. Good luck.
Electronics Forum | Thu Feb 06 01:56:53 EST 2014 | aflex
Hey, First you need to check if the I/O port setting is ok. Also how many jumpers are you using? Atlast always connect JP4 to PLD registers base address
Electronics Forum | Mon Feb 10 14:29:01 EST 2014 | dilogic
Sorry, I did not check the forum for a few days. Slot 12 controller is in charge for PWC and Beam1 Head1 (front) theta and Z axes. Which sw. version is installed on your machine?
Electronics Forum | Tue Aug 12 08:35:28 EDT 2008 | avalancher
Many years ago... my old engineer used a very simple unit bought at Radio Shack. It was a device that they use in door ways to announce someone was entering the store. It used a beam of light and when the board broke that beam, a bell/ring/noise wou
Electronics Forum | Wed Jun 02 09:50:00 EDT 1999 | Earl Moon
| Hello all | I have a question concerning whether or not there is any special requirements to follow for assembly of a Polyimide PCB card. The customer has the following information on there documentation but since we have never built anything with
Electronics Forum | Wed Jun 02 09:55:31 EDT 1999 | Jason Gregory
Hello Dan, I have recently started using polyimide, but not for the standard uses. I designed a pallet for holding small, thin (about .0018" thick) RF boards that were being reflowed inside their aluminum housings. They were screwed down to prevent w
Electronics Forum | Mon Sep 23 11:13:12 EDT 2019 | tsauve
I forgot to update this. Customer insisted on reflowing SIM card directly to PCB, as per their previous CEM. It worked. No deformation of the SIM card - assembly works - records data to SIM card. Note that using hot air reflow type (rework station)d
Electronics Forum | Tue Oct 25 07:02:05 EDT 2005 | mikesn
Anyone knows of a repairer out there who can repair a cognex 5000 series vision card? This card is taken out of a Camelot/Gemini II. Thanks Mike.
Electronics Forum | Mon Nov 01 14:35:44 EST 2004 | pdeuel
I have a total of 3 of these types of cards that have malfunctions of various types that I need at least one fixed. Can anybody out there help? Can anybody offer support to troubbleshoot this problem or the problems with our other cards, to component