Electronics Forum | Sat Aug 28 14:16:18 EDT 1999 | JohnW
Doug, Have you tried running the boards at an angle to the wave of between 15 - 30 degree's ? I've done this on a few boards to eliminate short's and I believe it will work on your problem very sucessfully. Best thing to do is get your wave solder c
Electronics Forum | Sun May 23 07:13:56 EDT 1999 | Scott Cook
| Has anyone had any experience or data using vibration during the reflow process. | We introduced a vibration device attached to the fixed rail on a Vitronics reflow oven. The reason was to prevent skewing on large PLCC devices. The process worked v
Electronics Forum | Tue Jun 08 15:04:06 EDT 1999 | JohnW
| | | Hi,my master | | | How to iron out such soldering bridge with below conditions: | | | 1.The component(Harness)lead pitch is 2.0mm,the lead length is 3.2mm. | | | 2.PCB width is 1.6mm.Pad size is 1.65mm.Its a single copper PCB | | | 3.using s
Electronics Forum | Mon Mar 10 14:03:18 EDT 2008 | swag
Has anyone ever used local fids on flex circuits that are applied by the board house as black ink dots? Good or bad experience? We have a flex board that has two identical 60 pin, fine pitch connectors on it. From limited experience and reading so
Electronics Forum | Fri Jun 29 10:56:56 EDT 2012 | jorge_quijano
Hi guys, I need your advise on this, I have a very uncommon PCB design (at least for me, I've never seen anything like this...) it is 32" x 18" x 0.062" and has 9 QFNs that are driving me crazy, I'm not able to get a good alignment, I can get a mediu
Electronics Forum | Wed Nov 19 18:43:04 EST 2014 | gregcr
Hi All, I've been in the CM world for a long time and it seems like there has been little change in the packaging techniques used at the end of the day. Assembled circuit boards in small/flex volume are bagged or bubble wrapped and boxed up to ship
Electronics Forum | Tue Feb 09 18:53:20 EST 2021 | SMTA-64387083
You'll have to do at least 2up array since most conveyors won't handle boards less than 2in wide. I'm assuming it's FR4 lead free temperature material and PCB's are scored in the panel. The 13-16in lengths aren't a problem other than depaneling. With
Electronics Forum | Mon Oct 02 11:52:22 EDT 2023 | proceng1
We have these thin and flexible sheets of fiberglass that we sometimes use to send boards through reflow that can't ride the edge hold fingers. We've had these sheets for a decade at least and have no idea what they are or where they were purchased
Electronics Forum | Wed Sep 15 03:11:33 EDT 1999 | Charles Stringer
| | | Hi, | | | | | | Recently encountered missing components problem at the SMT process. | | | Among 13 chip components from the same part number mounted on the board, only 4 ( located in a same row and next to each other) were missing after post r
Electronics Forum | Fri Aug 28 12:20:53 EDT 1998 | Earl Moon
| | | | Damn Wayne, | | | | | If I knew as much as you, Justin, Steve, his dad, and others know, or knew, I'd be happy to be the UGLY. The plus of a forum like this is it keeps us on our toes and keeps our brain cells alive or constantly searching fo