Electronics Forum | Tue Jul 11 16:12:24 EDT 2000 | dstamour
Dave, They are monolithic amplifiers and similiar things. case styles VV105, AF320, AF190, BBB and GD-24. We have a customer who wants all these trimmed before placing on the board.
Electronics Forum | Wed Dec 20 10:26:20 EST 2017 | slthomas
In most cases when we run into this we find that the manufacturer has produced a data sheet that's applicable to package styles rather than any specific part number. They can be hard to locate, though.
Electronics Forum | Tue Oct 26 09:02:30 EDT 1999 | Ed Zamborsky
I have worked on 2 BGA Connectors, both from Berg. A 240 and 400 ball package. You should contact Berg directly for information. I posted a link to their website below. Just in case I screwed up the link, go to www.berg.com and then "product catalo
Electronics Forum | Thu Feb 27 15:14:53 EST 2020 | SMTA-Alex
This happens with either old tape, the cover tape doesn't stay sealed on the left side, or is the seal is too far to the right, the knife lifts the cover tape. There isn't much you can do in this case. Your choices are: switch the component into an A
Electronics Forum | Thu Aug 12 00:02:29 EDT 1999 | dean
| We currently have 32 LEDs per board and are looking to change the LED from a gull wing package to another package. (possibly a chip type package). I have heard that some cases and LEDs do not like reflow. This part is not cost effective to have to
Electronics Forum | Fri Jul 02 17:15:52 EDT 2004 | Sam
You can't tell how a machine will perform on your particular board by looking at it place parts at a trade show. Usually they demo a best case scenario (parts in a simple grid pattern, few package types, etc.) You need to supply the board data for y
Electronics Forum | Wed May 12 07:53:28 EDT 2004 | solderpro
Lets make it easy on the poor guy, some are correct, check you profile but remember one thing most do not apply, it is important to match the type of paste you are using with the style of oven and configuration. send a direct email and I will give so
Electronics Forum | Thu Jul 30 14:16:32 EDT 1998 | Phil Crane
| WHAT SHOULD THE RATIO BE OF STENCIL APERATURE TO PAD TO GET GOOD QUALITY RESULTS. BY THAT I MEAN, A MINIMM OF SOLDER BALLS, AND LITTLE TO NO BRIDGING, SHORTS, ETC.. | RIGHT NOW WE ARE USING A 1:1 RATIO, BUT ARE INVESTIGATING REDUCING THE APERATU
Electronics Forum | Sun Aug 02 06:54:26 EDT 1998 | Bob Willis
You may liketo contact Chemtech in the UK. http://chemteck.co.uk as they have a new hand book on stencils and a design guide due for release shortly there is also some stencil information as a survey on types and price on my web sites under surveys h
Electronics Forum | Wed Jan 22 21:59:54 EST 2003 | davef
First, wheat beer is not intended to be consumed at this time of the year in the northern hemishpere. It is ment to be consumed on the back porch, while smoking the LARGEST cigar you own, after mowing the lawn on a day that is so hot that the dog ca
