Electronics Forum | Tue May 07 13:49:05 EDT 2019 | tey422
Like I stated before, I am not familiar with the machine. I can only make suggestions. If you found solder paste on the nozzle, clean it off to prevent part stuck to the nozzle tip. I would also check if the nozzle tips are being worn off; uneven we
Electronics Forum | Wed May 08 07:19:03 EDT 2019 | youngbuck
Hi Sankar, I have had experience with the SX and X2 so I'm not sure how similar ours is to yours but i can give you some suggestions. 1. As Thomas said you could do a vaccum check and make sure the 4007 nozzle has around the same settings as the ot
Electronics Forum | Fri Jun 12 18:21:52 EDT 2020 | proceng1
I've had components move in the pocket and cause mis-picks. Generally, the part moves, but settles in the pocket after a moment. So I slowed down the pick up speed. It gave the part in the feeder a chance to settle before picking.
Electronics Forum | Fri May 14 15:03:19 EDT 1999 | lima
| | Does anyone know of any industry guidelines for the exhausting of volatiles in reflow ovens? I've seen some numbers like 1,000ppm for the oven atmosphere, but is this typical? | | | | My concern is the volatiles in my WS629 solder paste may be
Electronics Forum | Wed Oct 06 08:49:22 EDT 1999 | Mark
| | I hope that someone can help me with my problem! I am experiencing a lot of glued on parts falling off in the wave solder machine. A little information about my process: 1)We use Loctite 3609 glue that is used up long before its shelf life 2)Ou
Electronics Forum | Wed Sep 10 14:14:03 EDT 2008 | gregoryyork
Yes why did the Electroless Nickel layer split this is the ROOT cause. My guess is still that the resist was slightly miss registered over the copper and therefore poor adhesion of the Nickel ensued OR like I said originally the resist had contaminat
Electronics Forum | Fri Mar 18 14:27:29 EST 2005 | pmd
Hold on, MyData can place no component and not detect error if the minimum and maximinum settings in the centering phase are within the mesurement of the tool it'self. Especially if the levels are down between the jaws. For insurance make sure the to
Electronics Forum | Thu Sep 29 05:37:56 EDT 2005 | dougs
for 0402's you should be able to run the turret at full speed, if you need to slow it down it means that your machine isn't set up properly. use the vision number that the manual tells you and make sure your feeders are properly calibrated, poorly c
Electronics Forum | Wed Oct 06 08:55:23 EDT 1999 | Brian Conner
| | I hope that someone can help me with my problem! I am experiencing a lot of glued on parts falling off in the wave solder machine. A little information about my process: 1)We use Loctite 3609 glue that is used up long before its shelf life 2)Ou
Electronics Forum | Tue Oct 05 18:37:19 EDT 1999 | Morris
| I hope that someone can help me with my problem! I am experiencing a lot of glued on parts falling off in the wave solder machine. A little information about my process: 1)We use Loctite 3609 glue that is used up long before its shelf life 2)Our
