Electronics Forum | Tue Apr 24 02:34:31 EDT 2012 | abyan
Hi..i have o project to make 3A Power supply, and i want to make it using SMD. I want to ask you about SMD capasitor, because i'm a newbie in this type of material.. Actually where could i found SMD capasitor with this specifications: -) 6800uf 35vol
Electronics Forum | Thu Dec 09 14:24:20 EST 2021 | dltechltd
Üdv! Köszönöm, már régen megoldódott! Ez a gép nem Hatvanból van, hanem a salzgitteri Boschból. Azóta volt még 1-2 probléma, de most kifogástalanul megy! Jelenleg az EKRA X5 tápegységével bajlódunk már közel 2 hónapja, mert menet közben elszállt.
Electronics Forum | Fri Dec 08 21:26:44 EST 2006 | billwestiet
You already have some good answers. A chemical isolation zone for RMA is a good idea. If you are looking for new see the two references you have and Austin America. If you are looking for used, see us at http://www.ietechnology.net. We presently
Electronics Forum | Wed Jul 12 17:17:04 EDT 2006 | fordf1502004
I want to thank you for your help. after further investigation into the panasonic machine one our technicians was able to fix the issue. The panasonic machine uses a 5 volt signal and normal smema uses a 24 volt signal. To make these 2 machine talk t
Electronics Forum | Wed Dec 23 12:24:37 EST 2020 | ilavu
1. Palm down the GSM and open the safety cover to check input voltage +12VDC (at KDC2 3PL pins 2 to 3) and output voltage +5VDC (at KDC2 2PL pin 4 to 3) at the DC/DC converter. The DC/DC converter is located inside the control panel assembly ("Nose c
Electronics Forum | Wed Jul 29 07:02:50 EDT 2009 | thanhnguyen
yes i did test it manually, and it working fine.At the plug in, that the only way to plug it. With my ohm meter,24 volt present when you turn it on. The wierd thing is it blowing during head going down,then will sucking up when it move up.Vacuum valv
Electronics Forum | Sun Aug 21 15:35:22 EDT 2022 | zadir
good afternoon, please tell me, maybe someone has encountered a problem on the juki 730/740 machine.we have a 24 volt 10 amp power supply broken on it (it stopped turning on completely) we changed it, but now stanou can't find the zero point, he come
Electronics Forum | Sat Dec 31 00:52:33 EST 2022 | sarason
Next step trace the RS232 cable. Check all output voltages on your power supplys, b oth loaded an d unloaded. Note any differences. Check he impedancesa of your loads ie is your 24 volt load only measuring a few ohms. You may have a short? sarason
Electronics Forum | Mon Aug 06 14:24:12 EDT 2018 | dleeper
I had a similar problem once on an acculfex. The root cause was a short on the one the wire harnesses connected to the print head. If I recall, most of the relays in an accuflex are actuated by the 24 volt bus, so if you have a short anywhere in tha
Electronics Forum | Wed Feb 10 14:33:40 EST 2021 | lewis_and_clark
Hi Tom, Spoke with our technical team and our feeder division tells me that the GSM Pneumatic feeders are not compatible with the Advantis Machines, however the Multi Pitch 24 Volt Feeders are. We have a large customer base that uses the Advantis m
