Electronics Forum | Wed Apr 07 21:49:44 EDT 2004 | Ken
My favorite kind of calibration is where the machine learns what it did incorrectly. Then fixes itself! However, there are many types of machines that rely on human feedback as to the results of what it did. nozzle calibrations involve many factors
Electronics Forum | Thu Dec 18 17:43:57 EST 2003 | JD
Good evening all, I have recently gotten rid of our old SRT rework station because of lack of use. Before dumping however I took the CCD camera and monitor in the hopes of turning it into a board inspection station. However, the camera and monitor
Electronics Forum | Mon Apr 26 03:00:43 EDT 2010 | fujiphil
Check the following... 1. Set the fiducial reading to SCAN... 2. Clean the half mirror of the fiducial camera... 3. Check the CCD Camera...maybe blown fuse inside. Hope this will help.... Good luck....
Electronics Forum | Mon Jun 11 11:07:04 EDT 2012 | wbtimms
take a look at http://www.tri.com.tw linear motors side cameras 3 ccd camera technology
Electronics Forum | Thu Jan 06 10:56:32 EST 2005 | Rob
If the Leds are not in close proximity then LDR's can be used connected to a node on the ICT/wired into a micro for a simpler board - you can then test for luminous intensity as well as absence. Else you could use a cheap CCD camera with some simple
Electronics Forum | Tue Jan 05 10:28:48 EST 2016 | paperbackryder
there is (or was), a CCD camera option to enable component heights up to 11mm part over part.
Electronics Forum | Thu Aug 10 12:51:05 EDT 2017 | emeto
I dug this in the past and I couldn't find much as well. It is a short history, as it is all based on a digital camera(first attempts start 80s and 90s). I want to say most of the applications of CMOS and CCD cameras we started seeing around the yea
Electronics Forum | Sat May 27 14:09:23 EDT 2000 | do ngoc hung
MAY YOU HELP ME TO SOVLE THE PROBLEMS IN MACHINE. I CAN NOT CHECK NOZZLES IN CENTER, BRIGHTNESS MODE OR THE CCD CAMERA CAN NOT CAPTURE THE NOZZLES. SO MAY I HAVE ANY INFO ABOUT IT. PLS GIVE ME A ADVICE ASAP VIA EMAIL. THANKS AND BEST REGARDS. DO
Electronics Forum | Thu Nov 04 11:03:24 EST 1999 | Chris May
We manufacture opto-electronics, small ccd cameras for pipeline inspection. I was wondering if anyone knew of a standard value for the recommended humidity of an assembly environment for optos in particular or for general electronic assembly. We had
Electronics Forum | Fri Oct 30 12:48:59 EDT 2009 | dannou
I've been the AOI programmer for around 5 years now. The equipment I use is the Orbotech VT-9300 & VT-9500 systems. The programming isn't too difficult, mostly Grey-scale shadow measurement through application algorithms. Three levels of lighting an
