Electronics Forum | Mon Apr 26 03:00:43 EDT 2010 | fujiphil
Check the following... 1. Set the fiducial reading to SCAN... 2. Clean the half mirror of the fiducial camera... 3. Check the CCD Camera...maybe blown fuse inside. Hope this will help.... Good luck....
Electronics Forum | Sun Apr 25 21:01:57 EDT 2010 | m79d
Hi all our IP1(1993)is not reading the board fiducials, the light comes on at the fid camera and stay on and the machine just hangs. Need to press the emergency stop button to go any further and screen says 'mark not readable'. None of the bulbs h
Electronics Forum | Sat May 27 14:09:23 EDT 2000 | do ngoc hung
MAY YOU HELP ME TO SOVLE THE PROBLEMS IN MACHINE. I CAN NOT CHECK NOZZLES IN CENTER, BRIGHTNESS MODE OR THE CCD CAMERA CAN NOT CAPTURE THE NOZZLES. SO MAY I HAVE ANY INFO ABOUT IT. PLS GIVE ME A ADVICE ASAP VIA EMAIL. THANKS AND BEST REGARDS. DO
Electronics Forum | Fri Oct 17 04:23:51 EDT 2008 | fujiphil
Check the image using the fast inching [F] and axis selection [2]. After vision error, press [F] then [2]. The monitor will display a binary images. You will now have a visual look on how the error occurs. Adjust the CCD level of the camera until you
Electronics Forum | Wed Oct 15 17:20:57 EDT 2008 | mbrunton
2, I have to scroll down to the bottom to see the image... and the outline of the legs isn't very clear. The legs are sort of blurred together. I had tried lowering the CCD offset in the part definition to -50, but it still looked bad. Could this
Electronics Forum | Fri Apr 21 20:00:29 EDT 2000 | Larry Johnson
I have been programming FUJI equipment for about 7 years now, and I am yet to fully understand this. PLCC's on an IP3. Front light, back light? Any CCD Level offsets? I just can't seem to get a good PD that will pass vision consistently. Can anyon
Electronics Forum | Fri Apr 21 23:12:35 EDT 2000 | Dean
Larry... I believe CCD offsets are not active on the IP3. Light levels and offsets are only availble in proper. Use Front Light. Use a P-pattern with bright lead, dark back background (I think #3)... The trick is to sample the lead width at the br
Electronics Forum | Sat Aug 22 00:23:10 EDT 1998 | Arul Vanan
We are using PCBs of CEM3 Material with bare copper fiducials. The whole board is of bare copper with a lacquer coating (Coats brother S2974). The fiducials are of 1 mm diameter bare copper. we use Panasert MV2F as well as Fuji CP4-3. In both the m
Electronics Forum | Thu Sep 10 09:21:27 EDT 1998 | Y.F. Michael Kou
| We are using PCBs of CEM3 Material with bare copper fiducials. The whole | board is of bare copper with a lacquer coating (Coats brother S2974). | The fiducials are of 1 mm diameter bare copper. we use Panasert MV2F as | well as Fuji CP4-3. In bo
Electronics Forum | Sat Aug 22 00:11:49 EDT 1998 | Arul vanan
We are using PCBs of CEM3 Material with bare copper fiducials. The whole board is of bare copper with a lacquer coating (Coats brother S2974). The fiducials are of 1 mm diameter bare copper. we use Panasert MV2F as well as FUji CP4-3. In both the mac