Electronics Forum | Mon Oct 22 20:41:32 EDT 2007 | jkhiew
Hi Dave, The solder has tended to wet the component termination of Ag/Pd (chip capacitor) but has not wetted the pads, whereas the solder has wetted both termination & pads when using Ag/Ni/Sn finishes. Thks
Electronics Forum | Thu Apr 15 11:13:24 EDT 2004 | pjc
Sn corrosion effects were studied for stainless steels, coated stainless steels, titanium, cast iron, and other materials. This study can be found in the SMT Library under "Equipment Impacts of Lead-Free Soldering" Electrovert uses a Melonite coating
Electronics Forum | Thu Dec 06 23:34:25 EST 2001 | Beny
Pls. help. I�ve problem with non-wetting defect at capacitor termination. I have faced this problem at the 2 kinds of termination. One is chip capacitor 0603 that its outer termination surface composed with 100 Sn (Lead free) and another one is Sta
Electronics Forum | Mon Dec 10 04:15:01 EST 2001 | Beny
Thanks for your advise Now I don't found Non-wetting defect at TIN COATED 0603 after I had increased peak temp and Time above 183 C. At film caps, I still found Non-wetting in high rate at film chip size 2416. I using PANASONIC's part with identif
Electronics Forum | Thu Mar 26 11:25:21 EST 1998 | Earl Moon
In December and January (1997 & 1998) a number of people requested information regarding component cracking. I overlooked this until recently thinking design and process requirements were violated. After reviewing the last 14 months consulting effort
Electronics Forum | Wed Jun 03 13:50:32 EDT 1998 | Chrys
| Can anyone tell me if there is a reference for smt component height specs on the bottom side of a board, which will also go through wave soldering. A current design I am reviewing has tant caps(7343) and a crystal on the back side. Should I only b
Electronics Forum | Mon May 25 21:10:28 EDT 2009 | padawanlinuxero
Hello !! I have a problem with my wave solder oven, in one of the products we made has connectors on one side of the pcb and in the other one has SMT components the process is kinda tricky on the SMT components we use an adhesive and put to the refl
Electronics Forum | Tue May 26 06:56:40 EDT 2009 | xinxi
Hi! From your post, it seem like the wave did not really touch the component. You probably need to get the both wave height correct and that it hits the component.It is normal for solder to come through the PCB when using chip wave. The through-hole
Electronics Forum | Tue Jan 19 10:27:33 EST 2021 | grahamcooper22
Anyone experience high voiding levels in SMT lead free solder joints when the CHIP has bright tin plated end caps ? In the same process, Matte tin plated CHIPs don't show any voiding issues.
Electronics Forum | Tue Jan 29 08:21:50 EST 2019 | electronics101
Hi All, Can someone please help, I have a number of tall surface mount components that according to IPC 610 (8.2.2.3) are a fail due to the end termination not wetting at least 0.5mm + solder height. The components are very well soldered but the sol
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411