Electronics Forum | Thu Aug 21 21:05:28 EDT 2003 | davef
Try: http://www.circuittechctr.com [We have no relationship nor receive benefit from the company referenced in the above link.] Alternately, the fine folk and Denny Ferry at Circuit Technology Center [above link] list processes for removing confor
Electronics Forum | Fri Feb 20 08:44:05 EST 2004 | davef
Lucky guess, eh? [Sorry to blow your theory on bad parts] A 1000 of these boards on the line, ummm. Two ideas to consider: * Increase the conveyor angle [don't get carried away, just keep the angle below 8*]. * Balance the flow of solder so that th
Electronics Forum | Fri Feb 27 07:59:47 EST 2004 | cyber_wolf
Is it true that a DEK printer will not accept a standard 20X20 stencil. I have heard that the image on the stencil is offset as well.(you need special stencils just for DEK printers?) Do they make an adapter to accommodate standard 20X20's with cent
Electronics Forum | Fri Feb 27 09:14:40 EST 2004 | cyber_wolf
To simplify; Can I take a 20X20 stencil with a centered image off my shelf and drop it into a DEK printer. OR...Does DEK require a special stencil like Fuji's do ?
Electronics Forum | Fri Feb 27 09:48:56 EST 2004 | pjc
DEK can take the 20x20 frame with an adapter. Stencil image is center justified. Contact DEK for p/n and price for adapter.
Electronics Forum | Fri Feb 27 12:06:03 EST 2004 | jseagle
A 20 x 20 frame with the image centered will drop in IF you have a printer with adjustable rails for the stencil, the rails move in and out to accomodate 29 x 29 to smaller than 20 x 20. Otherwise, you will need the adapter. James
Electronics Forum | Wed Mar 03 13:33:25 EST 2004 | stefwitt
How well should the fiducial be centered in the teach mode? Consider that you see the fiducial with probably 40 times magnification on the monitor. If you see the cross-hair a bit off center, then this is most likely just by a few hundreds of a milli
Electronics Forum | Thu May 13 17:06:07 EDT 2004 | Longhua
Mydata's tech support is iffy, at best. The techs are ok (slow as hell...) But they are trying to turn the servicing into a profit center...a $2000.00 PO just to come in the door???? The machines are quirky, too...
Electronics Forum | Mon May 24 14:49:39 EDT 2004 | Cal
Depending where you are located there may be a training center near your factory. You could have someone visit you on site or you can send someone for training and they can come back to teach others how to inspect. Where are you located??
Electronics Forum | Wed Jun 02 19:03:11 EDT 2004 | black5629
My board is in the center, it appears that it would read the stencil but not the board. " Board Model NOT found".I am open for any input.
