Electronics Forum | Fri Jun 11 06:06:41 EDT 2004 | davef
Have your designer place the via on the edge of the pad, centered and cover it with soldermask. If this is a leadless capacitor or resistor-style component, the corresponding pads will need to partially covered with solder mask to match the via in p
Electronics Forum | Wed Jul 28 02:44:29 EDT 2004 | kent_peterson
Bulb's + has them. Just the bulb! you have to center the new one as best you can. It's been so long since I bought one can't remember the bulb watt. If you need it I can get the numbers if you can't read your bulb.
Electronics Forum | Thu Aug 05 17:33:10 EDT 2004 | russ
We get this from time to time and I have found that a lot of times the customer or somebody has broken the joints from flexing or other handling. Is this component in the center of the PCBA? Russ
Electronics Forum | Thu Nov 11 10:25:10 EST 2004 | Hiram
Brian, Try this company. I think it is what you are looking for. Thanks, Hiram Aqueous Technologies Corporation 9785 Crescent Center Drive, Building 302 Rancho Cucamonga, CA 91730 USA Phone: + 1.909.944.7771 Fax: 1.909.944.7775
Electronics Forum | Thu May 19 03:43:31 EDT 2005 | grantp
Hi, If you mechanically center, then you cannot use the HYDRA head, so you only place one 0201 at a time. That's not a great solution, so you need the MYDATA to be stable with vision. I think whichever machine has better vision would be the choice.
Electronics Forum | Sat Apr 30 14:18:30 EDT 2005 | dr. klein
hello. i would like to know which program is recomended for setup verification. i know about 2 options, 1) siemens setup center verification, 2) diplan setup verification. which onw is better?
Electronics Forum | Wed May 04 11:49:24 EDT 2005 | thomasleetch
Does any one have a picture of a unversal stencil adapter for a SPM printer? We have stencils for Dek machines that are 25" by 23"wide that we need to turn 90 degrees to be able to center the pattern for the spm printer.Or do you have one for sale? T
Electronics Forum | Wed May 04 11:51:45 EDT 2005 | thomasleetch
Does any one have a picture of a unversal stencil adapter for a SPM printer? We have stencils for Dek machines that are 25" by 23"wide that we need to turn 90 degrees to be able to center the pattern for the spm printer.Or do you have one for sale? T
Electronics Forum | Fri Jun 10 13:50:51 EDT 2005 | jdumont
Can you elaborate? If the point of local fiducials is to find the center of the part how could it matter on some machines and not others....?
Electronics Forum | Tue Jun 14 07:29:12 EDT 2005 | jdumont
So I set up a board yesterday and did a test run. It appears that the spacing does matter on my machine. It placed the part off-center the same amount as one of the fiducials. Im going to look more into fixturing and placement pressure adjustments I