Electronics Forum | Tue Dec 30 20:31:11 EST 1997 | Jon
I suggest that you look at a few things: 1) The SMD pads may be too small for the part. Try to conform with the IPC standards in pad design. 2) The parts may be misplaced during the placement process. Tweek the placement program and if that doesn'
Electronics Forum | Thu Dec 06 14:59:50 EST 2007 | ch
Hi All! Thinking about purchasing 2nd user Panasonic p&p machines (CM88s-M1 or MSR series...) but I didn�t know anything about it�s programming. So, I wonder do I have to use any off-line software by anyway or it is possible just to load centroid dat
Electronics Forum | Mon Feb 18 13:54:38 EST 2008 | bschreiber
Most stencil manufacturers use an automated stencil inspection system like our StencilScan AOI that compares the Gerber data directly to the stencil image. We provide the StencilScan AOI system to end users that wish to guarantee stencil / screen an
Electronics Forum | Tue Nov 07 13:15:09 EST 2023 | klauss
I have a problem about getting data on SPC from inspection program. when i tried to get saved data on SPC it says no model found.
Electronics Forum | Fri Jul 19 10:01:30 EDT 2013 | dontfeedphils
In a past life I ran F1 systems post placement / pre reflow behind a MyData My12E, so it didn't exactly have to keep up with a speedy chip shooter, but it did pretty well. The AOI would end up being the bottle neck some of the time, but not because
Electronics Forum | Tue Aug 27 18:14:12 EDT 2019 | spoiltforchoice
You don't want an AOI machine you want an FAI (First Article Inspection) like one of these http://www.aoisystems.com/Scanner-Based-FA-Inspector.html (note some of the products here call themselves AOI, arguably they are not.) Or https://www.quins.de/
Electronics Forum | Fri Oct 06 06:59:00 EDT 2017 | spoiltforchoice
I agree, in Essemtec's case all they needed to to make that 100% friendlier was let the layout visualiser be able to read and display some gerber data (paste and overlay). Otherwise the offline solution is to hold up a blank board/printout to verify
Electronics Forum | Thu Mar 15 17:19:03 EDT 2007 | bT_Solutions
By "digital video inspection system", I'll assume you mean AOI. I have only dealt with one AOI system, YesTech, and in my opinion I'd say that AOI is much more consistent and advantageous than manual microscope inspections. Specifically, with the Yes
Electronics Forum | Wed Nov 02 08:57:34 EST 2005 | russ
Don't have any graphics but they are relatively simple. 1. They do need to be put into the copper. 2. We usually use a 1mm circle but many other shapes and sizes are useable but I know that all machine will take a circle. 3. Maintain a keepout area
Electronics Forum | Wed Jan 19 12:54:17 EST 2011 | bdamico
Hello Mark, The centroid data you are currently using to program the MV-2HTL may be used with either platform. However, the libraries cannot be shared due differences in camera resolution. The MV-2HTL will have a 1.3 megapixel camera versus the 2 m
.gif)
.gif)
.png)