Electronics Forum | Tue Jun 19 13:13:07 EDT 2012 | rodrigo
Hi all, Is there a generic heating element I can buy for this oven? The Heller part number is 682991. They want about $300 for the pair which doesn't sound too bad for me but .... I'm not the one writting the check :-). Thanks
Electronics Forum | Sat Jun 23 15:02:19 EDT 2012 | davef
Someone told me that Heller Industries heaters and 350*C blowers have a lifetime warranty. * Check the Heller Industries site * Talk to your Heller Industries sales-type.
Electronics Forum | Tue Jun 26 16:05:26 EDT 2012 | smtvys
Hi i have many parts for heller, but i also build resistance costums or copy, let me know if you are interested on it.
Electronics Forum | Tue Jul 15 14:16:18 EDT 2008 | dwelch123
I'm not looking for a batch wash but for a small{ 15 foot or less } washer with heating elements at dry station, any suggestions?
Electronics Forum | Tue Jul 15 16:19:54 EDT 2008 | jax
Depends on $$$ 1. Austin American 2. Stoelting 3. Technical Devices 4. Many more smaller companies. Many of the small machines are used with Saponifiers / Detergents. Not sure what your needs are but you should be able to find what you are looking f
Electronics Forum | Wed Jul 23 23:53:23 EDT 2008 | bga_kid
The companies mentioned do have cleaners in mentioned foot print range. I would look at Speedline electrovert as well
Electronics Forum | Thu Feb 03 10:01:08 EST 2005 | Philj
Try heating a blank board on a hotplate to 183 deg C. with a board this thick, if the layer construction is poorly balanced, it may bend enough in the region of the ceramic capacitor for the soldered joints to crack it on cooling to ambient.
Electronics Forum | Wed Jun 23 08:47:32 EDT 2010 | mun4o
Hi, about location - components are in the diferent location on PCB.In the one PCB have 7 cap 560pF 0603 , and some of thenm are cracked, another are OK. When I look at 20x microscope , I can't see defect, but ICT measure from 200 to 350pf.When hea
Electronics Forum | Thu Feb 03 04:55:21 EST 2005 | Dougs
OK, component wide portion runs with the conveyor, so really both sides should heat and cool at the same rate. The crack is at the termination between end cap and ceramic body and run vertically up the end cap, so when we remove the cap it comes of
Electronics Forum | Thu Feb 03 12:21:15 EST 2005 | Chunks
Lets get to the simple things. Wave or Reflow? Wave soldered parts have a higher susceptibility to physical damage until they are waved. That�s were I normally see this type of break. Usually, the crack is a circular pattern in the cap if it�s fr
