Electronics Forum | Thu Feb 13 14:20:19 EST 2014 | globalpowerproducts
we set the pre heaters the same as the Electrovert. On the SHEO wave solder it is a much longer conveyor so we only turned on the last two pre heaters to match the Electrovert
Electronics Forum | Tue Feb 11 00:21:54 EST 2014 | bren
I suddenly encountered this error F-AXIS-C/9 Error says Axis has unstable zero point. Any advise?
Electronics Forum | Thu Feb 13 08:08:41 EST 2014 | cyber_wolf
The manual says to bake the edge chains at 400C to clean them. Is anybody doing this ? I need to take my edge chains to a heat treat facility to clean them ? I don't want to spray oven cleaner on them as they appear to be plated with nickel or so
Electronics Forum | Sat Feb 15 10:31:53 EST 2014 | marcpeo
Sorry to say that most top out at 350 deg. Best to have it done outside. Is the chain locking up or not moving smoothly? If no signs of sticking then maybe no need to heat at all.
Electronics Forum | Mon Feb 17 03:23:33 EST 2014 | cunningham
Does anyone have a company that can do wash profiler? I want something similar to thermal profilers like your Kik and Datapaq but obviously it needs to be water proof. I want to measure temperature and pressure from the jets as part of a weekly SPC
Electronics Forum | Wed Mar 12 09:20:53 EDT 2014 | neiderman
There are a few companies that sell the pressure senors and software to data-log and map the coverage and pressure of fluid spraying systems.However they tend to be expensive. If you would like the link please send me an email and I would be happy to
Electronics Forum | Tue Feb 18 11:06:49 EST 2014 | cunningham
Does anyone do this? We have a small booth and lots of different kinds of media to try. it will be local stripping of coating on components for rework purposes. My main concern is ESD levels and how best to measure this. Any ideas or any papers o
Electronics Forum | Wed Feb 19 06:20:05 EST 2014 | bandjwet
These micro ablation stations can be outfitted with air ionizers and you can use less electronegative materials like corn starch as the blast media. Laser ablation works on parylene and other coatings when on metal surfaces. BWET
Electronics Forum | Thu Feb 27 19:07:53 EST 2014 | padawanlinuxero
I dont know if this helps but we do a 10-board-cleaning after 10 prints or cycles we stop and with lint free towels with alcohol and a air gun we clean it, you should clean one side then the other. Hope it helps
Electronics Forum | Thu Feb 27 23:50:09 EST 2014 | ilatintj
I would like to speak with you. In many cases with our new COBRA 3.0....we have been able to help eliminate Steps 1-3 mils....would this be of support to you? Pls email me jv@interlatin.com.mx
