Electronics Forum | Thu Dec 20 04:15:17 EST 2018 | aantonielli
thank you for the information, I've seen that Delta srl went bankrupt, so I imagine the know how has been definitely lost, isn't it?
Electronics Forum | Wed Dec 19 08:34:01 EST 2018 | charliedci
I'm not a big "adviser" on this forum, usually asking more than advising, but I do agree. It is good humor when needed.
Electronics Forum | Fri Dec 21 10:16:23 EST 2018 | jdengler
When an older Fuji machine acts odd the first place to go is a reset start and reload proper, program, and status to see if that fixes it. Just make sure you have a good proper before you begin. Jerry
Electronics Forum | Fri Dec 21 10:33:03 EST 2018 | kdexter0928
Thank you, Jerry. I have done a Fuji wash and resent proper and status, still no luck. I'm going to go through my proper and ensure it is indeed good.
Electronics Forum | Sun Dec 30 22:58:00 EST 2018 | assuredtech
DEX, The MTU has it's own proper and status separate of the IP2, are you sending both? Ed
Electronics Forum | Wed Jan 02 09:18:48 EST 2019 | kdexter0928
As far as I can tell In the software I am using it has them combined. I am using ProSMT+. I don't see any option to send a separate proper for the MTU alone. Am I missing something?
Electronics Forum | Wed Jan 02 09:28:56 EST 2019 | kdexter0928
Would I need to have the mtu in in the line as a separate machine? you know how good ol' ProSMT is, nothing seems to work how it should.
Electronics Forum | Wed Jan 02 09:41:00 EST 2019 | jdengler
Open Proper Editor in the IP2 Machine box On the right side you will see boxes Near the bottom 1 box would be MTU Click on that. Load data from file. Send to machine. Jerry
Electronics Forum | Wed Jan 02 09:54:31 EST 2019 | kdexter0928
These are some screenshots of the operator interface. I may be overlooking something, but I don't see any type of options for the MTU.
Electronics Forum | Wed Jan 02 10:31:40 EST 2019 | kdexter0928
Not a problem! I appreciate all the help! They all travel in the correct directions. Do you know which input card I should be looking at to check the range switches?
