Electronics Forum | Wed Sep 23 04:15:44 EDT 2020 | pkmkabigon
Hi all, I have a concern about how to prevent the component from bouncing out of the carrier (embossed pocket). I don't know what the reasons for this problem. Can anyone help me explain and show me the solutions to fix. Tks
Electronics Forum | Wed Sep 23 08:33:05 EDT 2020 | Modmatrix
Hello to everybody! Do anyone have a operator and main software manual and Service manual? Please send it to me. Thanks ( sidewinderx@libero.it)
Electronics Forum | Wed Sep 23 11:23:58 EDT 2020 | umapoly
Hello Everyone please help me identify the Inductor with specification as Inductor 26mh 0805. This is a very critical Inductor for my project, however, this small Inductor couldn't be found.
Electronics Forum | Wed Sep 23 12:30:49 EDT 2020 | kylehunter
You'll be searching for a while... There's no way you can have that large of inductance in an 0805 package. You'd be hard-pressed to even have a 1mH in an 0805.
Electronics Forum | Tue Oct 06 16:35:11 EDT 2020 | stephendo
I was about to suggest going to a smaller inductor and using traces to make up the difference. But I don't think that will work with mH.
Electronics Forum | Fri Sep 25 05:27:41 EDT 2020 | SMTA-64386317
Hi All, There is a problem which tin platting pad not able to get good wetting after reflow process while OSP pad able to achieve good platting. Where should I look to improve wettability at tin platting finishing. There is no component mounting on i
Electronics Forum | Sat Sep 26 14:07:09 EDT 2020 | davef
Print no paste on the tin-plated, [test???] pad. Experiment by putting Kapton tape over the stencil aperture for the tin platted pad. Re-assess your reflow profile, since the liquidus of the two plating materials will be different. Evaluate your pa
Electronics Forum | Tue Sep 29 18:54:17 EDT 2020 | smitty
Has anyone experienced issues with the Red-E-Set support system damaging components on double sided boards? How's the setup, its advertised as quick? Any issue with misprints using this support system?
Electronics Forum | Wed Sep 30 13:49:06 EDT 2020 | emeto
I would prefer wave for this parts, but if it not an option, cut 6-8mil stencil and double stroke it on the printer. All the rest is adding additional steps/labor/cost that is not worth it.
Electronics Forum | Wed Sep 30 15:28:49 EDT 2020 | spoiltforchoice
If you could change the design, a 2x25 1.27mm pitch surface mount connector is a standard part from Wurth. Samtec also do versions in any pin count you might desire, with locating pins, without, with picking clip etc.
.png)
