Electronics Forum | Tue Dec 14 12:41:56 EST 1999 | Kris W
Glen, Although the previous answers probably fit the problem you are having, we recently found that during pin insertion on an Autosplice machine, the gold was flaking from the pins and lodging between the legs of surface mount components. It would
Electronics Forum | Thu Dec 09 15:03:39 EST 1999 | Andy Yates
I would suggest that as well as repeatedly inspecting the same board and looking at the standard deviations of the measurements, you should perform some form of accuracy test either by measuring a known glass plate or by inspecting a board at 0 and 1
Electronics Forum | Thu Dec 09 00:15:55 EST 1999 | Vinesh Gandhi
Thanks for your feedback. I definitely agree with your viewpoints. Can you send across any documents/papers through e-mail or post them on the smtnet which clearly describes the HARMFUL EFFECTS OF WHITE RESIDUES. My customer's only apprehension is
Electronics Forum | Mon Dec 06 09:16:22 EST 1999 | Dave F
Russ: Three things: 1 Wolfgang is 100% correctamundo about the slow dissolution rate of gold 2 Shear stength of the gold 63/37 solder connection decreases rapidly, as the gold content of the solder connection increases above 2%. 3 There are many
Electronics Forum | Mon Dec 13 00:05:28 EST 1999 | Dennis O'Donnell
I can't figure out why everyone is plating everything with gold. According to the J Standard, gold plating should be removed before soldering to the surface. The gold, when left on the surface to be soldered will contaminate the solder joint and ca
Electronics Forum | Mon Dec 13 16:07:38 EST 1999 | Travson
Russ, Regarding your no clean soldering to gold. We have been doing that for about three years now. We have been using 62/36/2% silver solder paste. I have not done any thorough testing as to joint strength but the finish is shinier. It looks li
Electronics Forum | Fri Dec 03 13:50:09 EST 1999 | Larry Johnson
I thought that you guys were going to change the site back to the way it was. Where you could read all the responces to a posting at once, without haveing to "click" on each individual responce. It wouldn't be that big of a deal, if the site ran qu
Electronics Forum | Fri Dec 03 12:45:28 EST 1999 | Bill
I'd like to print out a forum item to fax to a friend who does not have internet access or email yet at his new facility, but no matter what I do to my printer set-up I cannot get the full page width to print. The right side of the message keeps gett
Electronics Forum | Sat Dec 04 10:12:55 EST 1999 | Michael Bryant
Bill, As Cunli said, there is a link at the top of each message page that will pop open a printer friendly version. Before we added that feature, the only solution was to print the page in landscape mode. The printer friendly version is not a fixed
Electronics Forum | Mon Dec 06 08:20:47 EST 1999 | Bill
Mike - I had tried the "printer friendly version" before I sent my original message last Friday. The result may have been "printer friendly", but it wasn't very "reader friendly". All the words printed but the printout removed all the formatting so
