Electronics Forum | Tue Jun 01 08:30:51 EDT 1999 | Dave F
| I have difficulty to convince my management to air-condition our manufacturing facilities. The room temperature fluxuates from 8 deg.C in the morning to 25 deg. C in the afternoon. The PCB topside temperatures in the reflow oven and wave soldering
Electronics Forum | Thu Jun 03 18:53:27 EDT 1999 | Raeto Zryd
| | I have difficulty to convince my management to air-condition our manufacturing facilities. The room temperature fluxuates from 8 deg.C in the morning to 25 deg. C in the afternoon. The PCB topside temperatures in the reflow oven and wave solderin
Electronics Forum | Sat May 29 16:04:49 EDT 1999 | M Cox
I have always thought it to be a good practice to wash SMA's with water soluble paste (WS609) soon after reflow. Is there a time limit as to how long a board should sit after reflow before washing said board? For instance; processing a double-sided
Electronics Forum | Sat May 29 14:34:34 EDT 1999 | Mark D.
Is it possible to place parts that do not have leadframes exposed when looking from the top side of the part such as BGA's using a Fuji IP1 with a SMD1 vision (Binary) system. I realize that the IP1 does not have front lighting but according to a Fuj
Electronics Forum | Mon May 31 09:46:28 EDT 1999 | KEVIN SIMPSON
| We are looking into frameless stencil systems for screen printing. Outside frame size of 29x29. | | Pros: smaller storage requirements and cheaper stencils. | | Cons: sharp metal edges, additional change over time required | | Can anyone relay
Electronics Forum | Tue Jun 01 15:32:59 EDT 1999 | Mike Murphy
| We are looking into frameless stencil systems for screen printing. Outside frame size of 29x29. | | Pros: smaller storage requirements and cheaper stencils. | | Cons: sharp metal edges, additional change over time required | | Can anyone relay
Electronics Forum | Wed Jun 02 06:58:40 EDT 1999 | Earl Moon
| | We are looking into frameless stencil systems for screen printing. Outside frame size of 29x29. | | | | Pros: smaller storage requirements and cheaper stencils. | | | | Cons: sharp metal edges, additional change over time required | | | | Can
Electronics Forum | Fri Jun 04 12:23:04 EDT 1999 | tannlin
| | We are looking into frameless stencil systems for screen printing. Outside frame size of 29x29. | | | | Pros: smaller storage requirements and cheaper stencils. | | | | Cons: sharp metal edges, additional change over time required | | | | Can
Electronics Forum | Fri May 28 17:30:35 EDT 1999 | Dave Clements
I discovered that we have some gold plated (30 mico in.) through hole connectors which were Paste In Hole soldered (60 sec at reflow) on a HASL PCB. Do we have an embrittlement reliability issue? The calculated volume % of gold in the joints is about
Electronics Forum | Thu May 27 22:29:14 EDT 1999 | Mike Flori
Does anyone have a suggestion for a UV resistant black potting material? The material recommended by a local vendor turned gray in a couple of months in the sun here in Florida. We are using L.E.D.'s in a small housing (about 1.2" cube) and need to s