Electronics Forum | Tue Apr 13 13:20:00 EDT 1999 | Hunter
Dear all, We are a newly constructed factory for Computer prehpirals assembly . We are looking for a company which can supply a complete BOMS for the following items. You can recommend the models as well - Mother Boards (with/without) SBlaster. - SD
Electronics Forum | Tue Apr 13 08:08:33 EDT 1999 | Rob Palson
We process both tin/lead plated boards and gold plated boards in our surface mount group. I have used Sn62/Pb36/Ag2 solder paste on all gold plated boards to help prevent gold scavaging. To reduce the amount of different solder pastes we have to bu
Electronics Forum | Mon Apr 19 02:38:41 EDT 1999 | Brian Sloth Bentzen
| We process both tin/lead plated boards and gold plated boards in our surface mount group. I have used Sn62/Pb36/Ag2 solder paste on all gold plated boards to help prevent gold scavaging. To reduce the amount of different solder pastes we have to
Electronics Forum | Wed Apr 14 00:29:28 EDT 1999 | Scott Cook
| Thanks all you kind and knowledgeable folks. I no longer will be participating in this forum. | | After careful consideration, I have come to the conclusion registration, in the manner required to participate in what was an open forum, is not my
Electronics Forum | Mon Apr 12 16:38:07 EDT 1999 | D. Lange
I have one assembly needing amp Z-Pack connectors installed (106509-1 & 106510-1). They require very expensive tooling part numbers for tooling are as follows: Bench model (SM-3, 814700-2) or Hydraulic floor model (SM-10/20 803880-6). Each re
Electronics Forum | Sat Apr 10 01:11:37 EDT 1999 | forest
Our company is going to use BGA(1.27mm pitch) But I have heard of troubles with P-BGA. It is that cracks occured between solderball and gold plating of PCB during ICT(incircuit test). We know that gold plating of PWB is not good for BGA, so we decide
Electronics Forum | Thu Apr 08 10:04:08 EDT 1999 | Michael Bryant
Bob, Thank you for posting an extremely relevant technical question to the Forum. However, the entire message was posted in the subject line and the body was left blank. In the future, please use the subject line to summarize your message, and type
Electronics Forum | Thu Apr 08 09:10:31 EDT 1999 | Frank Johnson
Greg, We at Beau Tech make all size picks and probes for straightening leads and other repair/rework tasks. Sounds like you can use a 10-MilProbe for your job. Please visit the Beau Tech web site at the following address www.beautech.com or call u
Electronics Forum | Tue Apr 06 12:55:01 EDT 1999 | Patrick O'Connor
0603's and 0402's are being damaged by the water wash post reflow. PCA's are 1" X 4" and 2" X 2" approximately. We've adjusted water pressure so that the top-down is higher than the bottom up. The baskets have a .5" mesh spacing. Some baskets h
Electronics Forum | Tue Apr 06 16:09:25 EDT 1999 | Dave F
| Hi, | Somebody know how to calculate the size of pads for different IC's: QFP's, SOIC, SOJ, etc. | | any help is apreciated. | | thanks | | AC | Al: Justin's comments are well taken. Who should know better about pad sizes that the component m