Electronics Forum | Tue Apr 23 06:26:18 EDT 2019 | jfeustel
Kanetic did implement a feature into their PLC code that would allow for simple reversal of the board flow. This is why the conveyor suddenly reversed direction after so many years. Because the feature was invoked by holding down a button it was kno
Electronics Forum | Tue Apr 16 09:46:36 EDT 2019 | ttheis
We just bought a MVP Supra M machine and have put it under power but can not get the PC system to power on. I am following the power up procedure in the manual. Under power the conveyor controls work and the UPS backup turns on, but holding the key i
Electronics Forum | Thu May 14 10:45:43 EDT 2020 | 27475265854
> Here is the one for the MX series. The others > were for MPS series. They are generally the same, > but just in case you do proceed with the jigs, > follow this procedure. > Here is the one for the MX series. The others <
Electronics Forum | Tue Apr 23 10:31:59 EDT 2019 | laserpro
Hi all and thanks for viewing my post! My questions related to the subject line are as follows: 1. Does the Epoxy Solder Mask Layer of a PCB protect against moisture absorption? Is this a primary function of the solder mask? 2. Does exposed FR4 na
Electronics Forum | Wed Apr 24 13:49:19 EDT 2019 | griinder
I have a support question concerning setting the gridlock tooling in manual mode on a MPM Momentum Elite. I am printing the top side (bottom is populated with parts) of a thin, flimsy PCB. The Grid lock tooling bows the PCB upwards in Auto mode, beca
Electronics Forum | Mon Apr 29 12:45:00 EDT 2019 | slthomas
When you say "....is there a way to easily (or at all) reference parts with the same specs..." do you mean when ordering stencils, or are you trying to drive your designers to choose a package that you already have in play when they have package opti
Electronics Forum | Tue Apr 30 10:44:14 EDT 2019 | spoiltforchoice
You are a very confusing person, one minute you want to buy some cheap piece of crap and speed isn't all that important and now you want a Lambo! Different use cases will make different machines faster if optimised. Or for the rest of us they averag
Electronics Forum | Wed May 01 12:33:36 EDT 2019 | cyber_wolf
Depending on what you are doing, feeder cost usually outweighs the price of the pick and place machines. I have worked with almost all of the Fuji CP turret machines. I haven't touched any of the new stuff but I have seen it in person and it is impr
Electronics Forum | Wed May 15 09:33:16 EDT 2019 | kahrpr
All manufactures ratings on machines are way over blown. I am not shilling for Hanwha we have there equipment it runs good our SM471 averages 36k to 42k. there is so much that goes into how fast a machine runs such as board design type of parts, pane
Electronics Forum | Thu May 02 13:40:25 EDT 2019 | youngbuck
Hello All, I am having a issue with Siplace 80 F5 with parts placing of in the X direction after I do Zero Point Correction with tool and Full Calibration. I also do the Gantry Zero Point correction and parts still place off in the X about .200mm to
winsouce.jpg)