Electronics Forum | Fri Nov 02 12:33:07 EDT 2018 | cbart
Good day all!! I am looking to go paperless with my travelers and i'm wondering if anyone knows of a low cost tool/software to support this? I'm not looking for a full MES or ERP system, we have these, but they don't have options for a traveler. I w
Electronics Forum | Mon Nov 19 02:30:09 EST 2018 | robl
OK, so all GEM Machines & MG were built by Yamaha, and imported in to Europe & USA and other places by Philips. After a while Philips developed it's own machine - the FCM. Philips then sold off it's SMT division and it was rebranded Assembleon.
Electronics Forum | Mon Nov 19 11:02:40 EST 2018 | robl
The old YV-112 equates to the old Philips Comet, which had 16 heads. It could only go down to 0603 imperial though. Here it is in it's early 90's glory: https://tools.adoptsmt.com/equipment/?id=14777 Do I think the YSM40R will hit 200K per hour? p
Electronics Forum | Thu Nov 22 02:10:39 EST 2018 | robl
Probably just evolved - just different needs at different times. Back in the day for example there were lots of patents around turrets so different manufacturers went different ways. These have mostly run out now, so different technologies call for
Electronics Forum | Mon Dec 03 15:03:49 EST 2018 | dleeper
I can't open your spread sheet to see how you calculate this, but usually this sort of calculation assumes the leads are spaced symmetrically on both sides of the part and the center of mass is between them. Gravity pulls the part down, while the wet
Electronics Forum | Tue Dec 11 18:50:47 EST 2018 | vinzon02
HI Rob; The thermal conductive adhesive needs to apply heat to stick on PCB. It's surface has not adhesive tape to fix it before placement of IC. Process: 1.Place the epoxy adhesive tape on PCB. (IC middle part area) 2.Apply heat on epoxy adhesive
Electronics Forum | Tue Dec 11 15:10:11 EST 2018 | med_cezir
Hi Everyone We setup a new smt line consisting from ys24 and ys12. When creating new programs I used stock names and added to database but after a while I recognized even if I used same package before I have to add it again because stock number is n
Electronics Forum | Mon Dec 17 09:59:50 EST 2018 | crstarr
Hello - We have two Quad QSA-30As that won't boot. These two machines haven't been run since October (they are backup machines), and there were some heavy lightning storms that month. We think both mother boards may have been zapped. We replaced
Electronics Forum | Thu Dec 20 05:06:48 EST 2018 | premkumar_haribabu
Hi Team, We using one of tanatalum capacitor ( vishay) for many models , in this we facing mis-alignment & throwoff issues after post reflow stage. After my analysis,my suspection is that due to one side part termination design ( square cut) issues
Electronics Forum | Mon Dec 31 11:19:32 EST 2018 | robertbronx
We have in our Co. an used My Data SMT (Version 2.5.4d) machine but we have a problem. After creating the file we import with a flash drive.We load and set the two fiducials and after everything is done we try to EXPORT the PCB file instead of being