Electronics Forum | Sat Jun 26 21:17:34 EDT 1999 | Bob Huelsenbeck
Anyone having any conveyor rail shaking on Electrovert wavesolder machine model "Electra"? The conveyor shakes more with a pallet passing through the machine, particularly when the 20" pallet is passing from spray fluxer to the first pre-heater. Here
Electronics Forum | Mon Jun 28 12:51:08 EDT 1999 | Scott Cook
| Anyone having any conveyor rail shaking on Electrovert wavesolder machine model "Electra"? The conveyor shakes more with a pallet passing through the machine, particularly when the 20" pallet is passing from spray fluxer to the first pre-heater. He
Electronics Forum | Tue Dec 15 12:23:47 EST 2009 | swag
I have moved golden boards from chains to mesh as I got tired of fishing t-couples under the chain rail. I saw a 3-5 deg. decrease on top-side parts peak temp. (all t-couples were on top side). I had to bump zones 6 and 7 a few degrees to make up f
Electronics Forum | Sat Jul 23 02:16:52 EDT 2022 | poly
Is there are reason for going for larger (or smaller) boards when designing panels for use with a chain conveyor oven? My panels range from 0.6mm 2 layer (for touch with hatched ground) to 1.6mm 4 layer. I'm planning to go for smaller panels to reduc
Electronics Forum | Mon Mar 20 15:41:00 EDT 2023 | oclsc
Hallo SMTnet. We have just bought a VXS Air 3.2/634 Rehm reflow oven. We are wondering why the conveyor chain in the oven is still running two days after the "Auto OFF" precedure/program has been activated. In this case the oven set to "Auto Off" Fr
Electronics Forum | Tue Mar 21 11:57:27 EDT 2023 | stephendo
Or after a preset amount of time. Maybe the oven has a setting somewhere that is not set propely.
Electronics Forum | Mon Mar 20 22:08:24 EDT 2023 | tey422
For reflow oven to "auto off" it has to go through the cool down; it should be off went the cool off temperature is reached. Perhaps you need to 1st check if something prevent the oven reach the cool off temp (both hardware & software).
Electronics Forum | Mon May 24 10:17:37 EDT 2004 | Sue PH
Our old Trieber Wave Solder machine is needing it's conveyor chains to be cleaned. Does anyone out there have knowledge to share about dealing with this problem?
Electronics Forum | Mon Mar 20 06:21:42 EST 2006 | AR
Have a problem with Omniflo 5 (-97 vintage) pin chain conveyor. Occasionally the conveyor stops for a second or two, then makes a slight jerk, then stops again, makes a jerk etc. Then suddenly the problem goes away only to return next day (we switch
Electronics Forum | Tue Mar 02 00:57:11 EST 2021 | cbeneat
We use LUBCON Turmofluid 40 B.
