Electronics Forum | Tue Jul 17 16:40:31 EDT 2018 | sumote
I use Tribol 1421 https://thelubricantoracle.castrol.com/product/tribol-1421-sg-high-temperature-chain-lube
Electronics Forum | Fri Oct 12 16:29:21 EDT 2007 | dyoungquist
When we bought our Heller reflow oven, the installation technician recommended using Oberon chain lube part # 680784(0) when we needed to purchase more oil for our chain. I just went to the oberonlube.com website and could not find that part number.
Electronics Forum | Thu Mar 04 19:03:48 EST 2004 | pdeuel
Have you been re lubing chain after cleaning. Is the chain worn thru from friction on rails. How are carbonized particles removed from inside links after cleaning. What is recomended method for cleaning.
Electronics Forum | Mon Mar 01 21:14:26 EST 2021 | davem
Hey Guys, so I have 3 Vitronics wave solder machines to care for (2 x 6622 and a Delta 5) and they're in need of some TLC. One thing they look to be badly in need of is some conveyor chain work. I found a thread here on chain cleaning, but wanted to
Electronics Forum | Fri Mar 12 22:50:00 EST 2004 | JHahn
We pull our chains and fingers off of our wave and take them down to Carquest autoparts store and have them soaked in an engine degreaser. The then re-lube the chain and re-grease the rails when we first put the chain back on. This is the cure that
Electronics Forum | Tue Jul 12 17:21:34 EDT 2022 | markhoch
It is possible. If the talcum powder mixes with the chain lubricant, it could gum everything up. Back a few years ago when I was running an SMT Quattro Peak, I was having an issue with the conveyor chain drive motor going into overload. We had to pul
Electronics Forum | Fri Mar 05 15:24:55 EST 2004 | mrmaint
I have soaked the chains in a 5 gallon bucket with wd40. It does a great job cleaning the chain. After they are done soaking i take an air gun outside and blow the chain off. I found that using a medium temp lubricant does not cause alot of buildup o
Electronics Forum | Mon Jun 28 12:51:08 EDT 1999 | Scott Cook
| Anyone having any conveyor rail shaking on Electrovert wavesolder machine model "Electra"? The conveyor shakes more with a pallet passing through the machine, particularly when the 20" pallet is passing from spray fluxer to the first pre-heater. He
Electronics Forum | Thu Mar 04 19:27:33 EST 2004 | russ
what I have usually found although not from wave conveyor chains but from racing motorcycles is that binding is caused by wear and bending and not dirt unless it is excessive to the point that you can actually see the dirt that is binding it. When t
Electronics Forum | Wed Dec 18 01:57:31 EST 2002 | MIke G
Be careful on how you go about this. Some older wave chains will have anywhere from a bit to lot of lead embedded into the grease. Ive had best luck sending it out to a shop that can hot tank them. Costs about $25 and it comes back all clean and lube