Electronics Forum | Mon Aug 14 02:24:20 EDT 2006 | AR
When we had problems on our Omni 5 with fluctuating chain speed, the problem turned out to be the Dart speed control board. After replacing the board the problem went away.
Electronics Forum | Wed Aug 09 11:45:25 EDT 2006 | SWAG
We have an OmniFlo 7, 2000 vintage reflow. We are having conveyor problems. I checked the encoder and speed control board and everything is good per tech. manual operations. We removed the chains a couple months ago and thoroughly soaked/cleaned t
Electronics Forum | Tue Mar 28 04:49:39 EST 2006 | AR
All's well that end's well: I replaced the Dart speed controller card and the problem disappeared completely. But no harm in giving the chains and the rails a thorough scrub although they weren't the culprit in this case. Many thanks to everyone for
Electronics Forum | Thu Apr 15 01:29:35 EDT 2004 | pyro747
Hello Everyone, I am having a pin chain speed problem. The speed of the chain will slow down after start up of the oven. Example if you set the conveyer to run at 41 in/min, as the oven warms up of conveyer will slow down phycally but won't chan
Electronics Forum | Thu Jun 30 18:28:47 EDT 2005 | KEN
1. Migrate to horse-shoe pad design. 2. Verify your furnace is level. 3. Verify your chains are not jerking around. 4. Speed control for fans / gas amplifiers are correct or normal? 5. (this happended to me once) Make sure you don't have any f
Electronics Forum | Mon Mar 20 06:21:42 EST 2006 | AR
Have a problem with Omniflo 5 (-97 vintage) pin chain conveyor. Occasionally the conveyor stops for a second or two, then makes a slight jerk, then stops again, makes a jerk etc. Then suddenly the problem goes away only to return next day (we switch
Electronics Forum | Thu Jul 23 13:23:45 EDT 2020 | bmalhi
Small components blown issue could be due to one of the below. - Process issue; Make sure solder paste is fresh, if flux is drying out it will not hold parts properly. Check downward pressure of Pick Place. SOT may have to be pushed a little harder i
Electronics Forum | Mon Jan 09 14:18:51 EST 2017 | ttheis
Thanks for your replies. Customer designed this so we can offer them feedback on the design. Pin manufacturer said most likely too much paste as well. Reducing apeture size would be the easiest solution there. We are running a VIP70 oven with chain r
Electronics Forum | Wed Oct 03 23:42:32 EDT 2018 | gaintstar
SMT Reflow Oven Factory http://www.flason-smt.com/product/SMT-Reflow-Oven-Factory.html Introduction of SMT Reflow Oven Factory: 1. Windows XP platform, user friendly interface and easily swap between bilingual of English & Chinese. 2. Digital contr
Electronics Forum | Tue Jul 16 02:18:42 EDT 2019 | sy332366
Specifications : S-8800 Number Of Heating Zones :Up8/Bottom8 Dimension (L*W*H)mm: 5310x1353x1490 Dimension (L*W*H)mm: 5310x1353x1490 Number Of Heating Zones : Up8/Bottom8 Length Of Heating Zones : 3121mm Control System : PLC+Computer Transmission Age
