Electronics Forum | Thu Apr 18 14:04:11 EDT 2013 | dilogic
Are you trying to bring up to life an old machine or the problem just started to appear? There might be several causes for this problem. As a quick fix, you can change in th settings logic polarity of that signal, so it will be OK when actually not.
Electronics Forum | Fri Apr 19 01:46:20 EDT 2013 | dman97
This machine had been off for a few months. After we booted it a few days ago, this problem popped up. How exactly would I change the logic polarity?
Electronics Forum | Mon Apr 22 04:19:09 EDT 2013 | dilogic
Parameters->Miscellaneous I/O then select Inputs and scroll down to REAR_P2P_TOWER_DOWN, select appropriate input and change State field from 1 to 0, then press OK and save.
Electronics Forum | Fri Apr 19 01:42:35 EDT 2013 | dman97
Sounds like you need to run the MINT program. Boot the machine into MSDOS mode change directory to mint and type load. Let the machine auto detect the cards and re download the software to all cards.
Electronics Forum | Wed Apr 24 12:54:36 EDT 2013 | smtventasmex
Hi i working now on electrovert omniflow 10 tha deos not control the speed of the conveyor on the sofware, i did change the encoder but this ones continue failing, this fail start because we have a short cut on smemma wire, any one have experience wi
Electronics Forum | Thu May 02 14:26:57 EDT 2013 | wahahasteven
Thanks for the advise, but we want to change the lacquer/thinner ratio at the last step if we don't have other solution.
Electronics Forum | Wed May 08 05:13:37 EDT 2013 | bobpan
Put up an e-mail address and i can send you a paper on setting up the current level to see if the board is working properly. The z-axis and theta-axis are swappable.....you just need to change the dip switch settings.
Electronics Forum | Tue Jun 04 15:16:44 EDT 2013 | smtventasmex
As far i know it is not jut a software modification, this include change on drivers, PS, and some more devices
Electronics Forum | Wed Jul 17 14:13:08 EDT 2013 | kenkay
We have an ICOM 6000 rose tester and everytime we run a program the machine stops and says "resistivity error". We have changed filters and calibrated the solution with no luck. Any ideas?
Electronics Forum | Tue Jul 30 11:58:50 EDT 2013 | gnus
Seems to pick up and place fine now. No idea why, didn't change a thing. Thanks for the advice everyone!
.png)
