Electronics Forum | Mon May 26 08:23:49 EDT 2014 | mun4o
hi all, we have smd line with 2 Assembleon topaz X.The real speed of the line is about 12- 13k cph.I want to increase this speed.I intend to buy a Assembleon sapphire and change one of topaz with sapphire ( chip shooter).Has anyone of you similar c
Electronics Forum | Thu May 29 22:06:24 EDT 2014 | proy
Hi You might want to join and post this on my Yahoo Assembleon users group, it is new so we only have 6 or so members, but as it grows it will be more and more useful. My 2c worth is that a sapphire might be kind of old and problematic for support
Electronics Forum | Mon Nov 12 13:35:34 EST 2007 | dyoungquist
MyData TP9s Work well in high mix applications because change over time from 1 job to the next can be done in as little as 15 minutes if you have the right mix of magazines/feeders. Component placement rates vary depending on which component you ar
Electronics Forum | Thu Mar 18 13:32:47 EDT 2021 | robl
No worries. If you look at the line in the foreground you'll see them changed over: https://www.wnie.online/aws-slovakia-achieves-as9100-revision-d-certification/
Electronics Forum | Fri Dec 15 11:01:14 EST 2017 | robertorocco
I have one Topaz X FNC machine with this problem. The head 2 FNC not change the nozzle. The head 4-6-8 is ok and change, but head 2 no, when he tries to change the nozzle he gives me an error message. What could be the problem?
Electronics Forum | Wed Oct 31 13:50:00 EDT 2018 | xenkok555
Check optical head height sensors.
Electronics Forum | Thu Nov 08 02:09:05 EST 2018 | vinitverma
If the nozzle gets changed properly but the machine still gives the sensor, then the FNC nozzle detection sensor needs to be adjusted. It is a set of 2 sensors on a plate on the either side of the FNC. If the nozzle is not changed successfully and ge
Electronics Forum | Wed Oct 23 13:01:11 EDT 2019 | compit
I have a single-view camera on a Topaz-X machine. When I define a connector type element - it displays messages like in attached files. If I change the type to IC - no problem. There is also no problem when "learning&quot
Electronics Forum | Tue Mar 06 15:53:57 EST 2012 | acsscott
I did optimize. All it did was change the order or the resistors it picked up and placed, and changed the order of the LED's that it picked up and placed. Still only four parts at a time.
Electronics Forum | Mon Jan 03 12:39:46 EST 2022 | vasu278
Is it necessary to set adjustment mode 2 during calibration but iam unable to change the setting after changing unable to save and the screen appears as shown in image below
