Electronics Forum | Tue Jun 03 08:33:06 EDT 2014 | patel_daxa29
Do I need to lower temperature of bottom zone (for common size parts) while reflow 2nd side of the board or I should be using same profile as I used for 1st side reflow? Will parts on bottom side will stay in place without changing temperature?
Electronics Forum | Fri Jun 13 08:00:57 EDT 2014 | sargeredarmy01
Haha, I can assure you sir I cannot see Russia from my house. Will admit that I do have some form of connection with the USAF. The error that comes up is a cycle alarm and a chuck set. I have attached a reference image of the machine screen. I als
Electronics Forum | Wed Jun 25 18:19:49 EDT 2014 | guts1872
During machine run, sometimes when we stop to change parts the servos wont start back up. There is a message on the screen that says "Amplifier is resetting power". When that message clears and push the servo on button nothing happens. There is an er
Electronics Forum | Mon Aug 25 11:43:30 EDT 2014 | fuji_user_2014
Looking for information on how to stop our Fuji from picking up parts in advance for the next board at the in carrier. In other words, how can we stop the machine from picking up parts before reading fiducials on a board without adding a skip mark t
Electronics Forum | Thu Aug 28 23:15:44 EDT 2014 | phyllishwl
Hi all, Our production reported that they found 3 panels out of 53 panels with strange phenomenon after reflow. 1/ Blister / Delamination of PCB panels, 2pcs blister/delamination under solder mask, 1pc under Gold plating at Gold finger 2/ Silkscr
Electronics Forum | Tue Sep 16 15:54:39 EDT 2014 | gascon5383
I have not tried running it 180 or 90 degrees out. The process involved to change that would be too large for my company to accept it. I see where you can adjust the board stop x and y but is there a way for the z axis? I have found that the board is
Electronics Forum | Tue Sep 30 12:16:23 EDT 2014 | tech1
Check your pad sizes against the supplier recommendation. I have noticed that these LED packages are very light and easily move around during reflow. Human nature has us checking the profile and making changes when in fact it is usually something els
Electronics Forum | Mon Sep 29 13:36:01 EDT 2014 | dustin
I came into work this morning to an error on one of my printers. After powering on machine, the error MACHINE DOWN popped up in the top left corner of the screen. I have the giant manual and could not locate a solution for this error. I have checked
Electronics Forum | Thu Oct 23 10:27:38 EDT 2014 | island2013
Is this happening on a new product you just introduced to the factory? If so, then I would check stencil design. Many moons ago we had a similar issue and discovered we were applying too much paste on the chip parts. We changed to a homeplate desig
Electronics Forum | Tue Nov 18 21:18:29 EST 2014 | sonavc
Thanks, I don't have change to try the Password Now my machine boot up and get " BLUE SCREEN " I screw up my windows NT. Does any one know who till service this machine, reinstall the software and application. I'm in Southern California , CA 92708