Electronics Forum | Tue Nov 11 21:21:54 EST 2014 | sonavc
Thank you, that is help, I always change in program and re-transmit. One more question, I program N_data with capacitor is TANTB (using M nozzles in part data). but when I run the program in machine it is always use S nozzles to pick the cap. TANTB
Electronics Forum | Wed Dec 17 10:35:39 EST 2014 | benreben
Hi all, i have installed an CP643E and when i put power ON,instantly i have the red led HALT goes ON on the cpu board (HIMV-134) i have change the board but same problem... do you have an idea of the problem? thanks Ben
Electronics Forum | Tue Dec 23 13:53:06 EST 2014 | jimmyboz
Hi all, > > i have installed an CP643E and when i > put power ON,instantly i have the red led HALT > goes ON on the cpu board (HIMV-134) i have > change the board but same problem... do you have > an idea of the problem? > > thanks > > Ben H
Electronics Forum | Tue Dec 23 08:31:34 EST 2014 | proceng1
I know the contract rules, but this is idiotic. I did find the 10.2.6 spec already, but I had not looked at the TM-650. I'll check that out, thanks. I also may have found another part that has a better clearance, so I also hope to use these specs
Electronics Forum | Fri May 29 14:19:14 EDT 2015 | dekhead
Offsets are there to for an alignment change over the entire board... alignment weighting is, essentially to account for imperfect match between stencil and board, and will allow you to concentrate best alignment to a given portion of the board (give
Electronics Forum | Wed May 13 10:34:57 EDT 2015 | squeekypigeon
If memory serves me right, if you are test picking a component which will be served to the machine via an LCS the 'pick position' will automatically set itself to feeder slot 1. If you change this to something more central (I used to use location 4
Electronics Forum | Sat May 30 07:06:42 EDT 2015 | et1972
Hi I have a MPM3000HI printing machine with a following problem : Unable to run at high speed for z axis ,machine will stop at certain points . Have change ballscrew,nut ballscrew,motor and brake but still the same. Now run at low speed at 1 but t
Electronics Forum | Thu Jun 04 02:58:48 EDT 2015 | oxygensmd
I saw the same problem before we changed to S20. S15 has a problem with the components. They can fall into the head easy. Try to remove the head, clean the inner encoder and check there isn't any small component. If you work with 0402 or same/smalle
Electronics Forum | Fri Jul 10 08:50:04 EDT 2015 | jax
Is the feeder working properly... presenting the label at the same location each time it indexes? If yes, I would look at changing nozzles on the machine. sometimes a rigid tipped nozzle cannot maintain suction on thin items like labels that can ben
Electronics Forum | Wed Aug 12 11:01:37 EDT 2015 | bnorton
Machine->Config and set all their addresses to 0. We have swapped the EPC5, the VGA Video, the Force board, and most recently the Lantern 630VME. Watching the Force board COMM2 with Logicomm, at the end of all the ldx file processing it changes to c
