Electronics Forum | Mon Aug 31 06:26:44 EDT 2015 | piyakorn
Hi At our SMT mounting found battery clip stick in the reel pocket and some dropped under pick&place machine from the nozzle can not pick out the part which got recommendation should change the nozzle type from standard placement to be clip sho
Electronics Forum | Thu Oct 15 11:07:23 EDT 2015 | aj
You should do a bit of research into Mirae Placement machines.. they took over the Quad machines and built on them so your feeders may still be compatible... I only know this because I spoke to an agent last week - I have never used quad or Mirae..
Electronics Forum | Thu Dec 10 09:29:29 EST 2015 | tsvetan
Any major brand (Samsung, Juki, Panasonic, Fuji) will work, most important is what service and support you will get *after* you buy the new machine. Once the machine is set and run, the most annoying part is to have downtime waiting for support quest
Electronics Forum | Tue Dec 01 23:22:23 EST 2015 | ttheis
Swapped the EXM-13A with no change; going to try the EXM-14 card next. Do the monitors split from one VGA port via a cable splitter? I'm still working on getting manuals for this machine so I'm learning as I go so far, thanks for the help.
Electronics Forum | Fri May 13 10:13:24 EDT 2016 | esoderberg
Have used a Pressure Products N29 stencil cleaner for many years with outstanding results. The fluid is Zestron Vigon SC200. Tank holds 14 gallons that lasts for 1 year providing that you change the filters every month and makeup the fluid evaporatio
Electronics Forum | Fri May 13 02:43:21 EDT 2016 | karts22
Hi, We have several fixtures for GenRad 228x tester and would like to change sensor plates as they are quite worn. The problem is that 3 fixtures have different plate sizes for the same IC, side length is 10-12mm. What would be the best size for sens
Electronics Forum | Tue May 17 14:10:42 EDT 2016 | bobpan
You should get hold of Automation Technical Services and see if they can tell you how to change to indexing. If you find out....post it on here to help others. I myself have never used ATS feeders (just never ran into them anywhere). Bob
Electronics Forum | Tue Jul 19 13:25:08 EDT 2016 | emeto
thanks for the great reply. Now you make me think that we should change both the motors and the platens. That looks like a lot of money for a 10year old machine. It looks like it has some issues with the wiper as well. do you think 20K for parts and
Electronics Forum | Wed Jun 22 01:57:28 EDT 2016 | sachinverma
we face the problem to last month dry solder issue.when we found PCB is dry. (PTH not fill not properly)then we change the parameter like flux Tank pressure increase 130 to 250. after these activity PCB is ok no dry solder found......but problem is o
Electronics Forum | Mon Jul 11 13:21:40 EDT 2016 | bradholland
well there you go. I found that trying different values in the "Placing Stroke" had a big effect. I changed it to 2mm and it placed them well, but I could see the board also flexing a little, went to 1mm and the problem came back, so have sat in th