Electronics Forum | Mon Jul 15 09:03:44 EDT 2019 | dekhead
It uses the same BS position regardless of feed direction. In right feed, it passes Board under the camera and when (board @ stop) sensor detects board has passed, drops the BS and reverses conveyor direction. There is "Right Feed Delay" parameter to
Electronics Forum | Tue Jul 16 16:15:14 EDT 2019 | dekhead
If a few extra seconds of cycle time won't hurt you, recommend putting at max (3.0 sec) it will cycle all the way over to the Board @ Left sensor before extending BS and reversing. Otherwise play with the timing and requirement may vary from product
Electronics Forum | Thu Jul 18 00:08:31 EDT 2019 | mk15
hank you for the tips. MOT boards have already changed. The sensor on the conveyor responds. In service mode, the WIDTH MOTOR - OK, HOLD MOTOR - OK, SET CONVEYOR - OK, only error TRANSPORT - F-MOT-MSETDYN conveyor transport / 1250: amplifier DC-link
Electronics Forum | Wed Jul 17 12:00:27 EDT 2019 | weglimir
Hello, Dek printer is starting successfully until "press System switch to initialize printer" but nothing happens when I press the button. What could be the reason? I've tried another pait of monitors with different system button, and it doesn't ch
Electronics Forum | Tue Aug 13 10:35:16 EDT 2019 | sankarseptember
In Siplace mounter if i remove feeder with component from feeder pallet in machine..and again i set feeder in same location machine does not to verify and indication become green.Is there any option for setup verification any feeder removed even for
Electronics Forum | Mon Oct 14 03:36:53 EDT 2019 | robl
Any major & stable new advances in the PCBA inspection arena anyone has seen recently? Marantz were looking into AI for simpler programming & defect analysis, and I saw some papers last year on neural networks & deep learning regarding inspection i
Electronics Forum | Thu Oct 24 03:28:45 EDT 2019 | mfurlandea
Hello, i need an information about Fuji Aimex II and the problem when you have a multi offset pcb and you need to mount some offset with one program and the rest with a different program. So process dispense paste, mounting, changing program and moun
Electronics Forum | Thu Aug 27 14:32:34 EDT 2020 | dekhead
Following a pressure error, if continue is pressed, the next print with THE CORRESPONDING squeegee should attempt to compensate by increase or decrease in pressure (as appropriate)... Is it: 1)Not changing at all? 2)Over compensating? 3)Under compens
Electronics Forum | Wed Nov 20 12:37:30 EST 2019 | compit
You bought quartz (at DigiKey), which should have 10 pF capacitors, and mounted on a demo board is from JFR - "(..) Load capacitance (CL): Series, 16pF, 20pF, 30pF, or specify (..)" - try changing the quartz capacitors, or check with an oscilloscope
Electronics Forum | Tue Dec 31 02:13:14 EST 2019 | agoesfirmanto
This PCB model has been in production since 2018 and stopped production almost 1 year ago, now it has started production again and I found this problem. at the time of production in 2018 this problem did not occur. while the parameter settings do not