Electronics Forum | Wed Jun 16 08:16:27 EDT 2021 | shmevan91
Hi, Could anyone shed some light why a mk5 13 zone heller ovens rail width won't auto adjust? has to be done by hand every time we change product. The board support rail will adjust just not the main rail, have tried swapping the two cards around bu
Electronics Forum | Wed Jun 16 21:34:28 EDT 2021 | damiendigilin
Hi Does anyone know how to fix Z Axis Zero Point Unstable on My Data MY15. The machine will pick 3 components then error Z zero point unstable. We have changed the Z sensor the Z DC Motor the Z positioning encoder. Thank you
Electronics Forum | Fri Jun 25 17:33:23 EDT 2021 | SMTA-64387687
Since you changed the motor and the encoder, we can rule them out. Did you check the ribbon cables for wear? Is it failing on the same 3 components? Is it failing around the same area on the board? Does it fail when you cycle a tool, multiple times?
Electronics Forum | Sun Jun 27 21:10:07 EDT 2021 | damiendigilin
We changed the encoder because the ribbon cable is soldered to the board. Both encoders seem to be working correctly beep tested the cable. We have tried different size components 0603,0805,1206 and different boards. It will place about 3 to 5 com
Electronics Forum | Sat Jul 10 08:42:49 EDT 2021 | pradeep14
Hi all, As per PCB design have to mount SOT 6PIN, BUT Customer requested to place the SC-70 6PIN component. I know that it's very challenging for this activity. Customer is not ready to change the PCB design. So we have to mount SC-70 6PIN Component
Electronics Forum | Thu Aug 05 14:55:32 EDT 2021 | tomdegas
Tom I did as you instructed but same results so I actually changed the harness that has the two sensors (LED and RECEIVER) on the Z motor with a new spare I had hoping that was the problem. Alas that didn't solve it either. Any other suggestions?
Electronics Forum | Fri Aug 06 17:19:46 EDT 2021 | SMTA-64387687
It seems to me that something is out of calibration. I noticed that you were reinstalling TPSys. Did this start after the reinstall? Did you restore a backup of your parameters, or recalibrate the machine with new values? Try changing the tools to "n
Electronics Forum | Fri Sep 10 15:15:09 EDT 2021 | majdi4
Hello to all , Could you help with this defect .. Tombstoning 0201 , always at the same place in board , only this component near to the coax connector..with a defect rate of 2 % ..All the process is perfect . i cheked : stencil design , SPI resul
Electronics Forum | Mon Sep 13 07:27:50 EDT 2021 | denism
There may also be a problem with the a thermoprofile. Measure the temperature of both contacts of the component, if they heat up not evenly and the soldered lead heats up faster, then the problem is in the profile. To solve the problem of misalignmen
Electronics Forum | Thu Oct 21 07:24:29 EDT 2021 | korb23
as its a customer product we cant change much of the process. the pins have gaps on them to allow for out gassing. its purely gravity when the solder is liquidous i believe. need a carrier as you say or a type of adhesive to hold them down. do you kn