Electronics Forum | Thu Aug 05 14:55:32 EDT 2021 | tomdegas
Tom I did as you instructed but same results so I actually changed the harness that has the two sensors (LED and RECEIVER) on the Z motor with a new spare I had hoping that was the problem. Alas that didn't solve it either. Any other suggestions?
Electronics Forum | Wed Nov 12 06:23:09 EST 2008 | griffin
One thing to consider regarding the capacitor, The leads are not 100% straight beneath the plastic bottom part. And if you align with regards to the two leads, the leads will be aligned to the pads of your board, but the body of the capacitor is look
Electronics Forum | Thu Nov 24 21:19:40 EST 2005 | smartasp
Hi, We are also a hig mix low volum plant situated in Sri Lanka and just installed 2 Opals inline from Assembleon with the feeder exchange carts for faster change over. This machines can be upgraded to Topaz by just installing 4 more heads. So far
Electronics Forum | Thu Jun 08 16:33:47 EDT 2017 | sumote
This may not be a solution to your problem, but something from my tuner car days jumped into my head. If you are running at 100% and not getting the height you need, change out one (or both) of your pulleys. A bigger pulley at the motor side, or a sm
Electronics Forum | Tue Jul 12 08:54:34 EDT 2016 | leeg
well there you go. I found that trying > different values in the "Placing Stroke" had a > big effect. I changed it to 2mm and it placed > them well, but I could see the board also flexing > a little, went to 1mm and the problem came back, > so
Electronics Forum | Sun Jan 28 03:54:19 EST 2018 | alexeis
Hi, We have a solutions that is exactly for you: QPlace - basic solution for machine programming including XY reading and validation (with reports), BOM reading and validation (with reports), comparing and merging BOM/XY information (with validation
| 1 |
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
