Electronics Forum | Fri Mar 08 07:26:38 EST 2019 | alexcouto
Good morning Bukas. Thanks for the help, I'll make that same change. I'll give you feedback later. Thank you very much
Electronics Forum | Mon Mar 25 11:37:25 EDT 2019 | alexcouto
Good afternoon KaHrpr, I understand that servo motors have a way of knowing how far they are. but how can I find out where to position the motor or how can I configure the motor to change its parameters? should I use any software that should be incor
Electronics Forum | Fri Mar 08 04:03:34 EST 2019 | alexcouto
Hello guys, I am not very familiar with samsung cp 45 neo machines, however, I am trying to repair a head that from what I was told was always disabled. I activated head # 6 and there was no movement in the first phase, I thought it might be the fail
Electronics Forum | Thu Mar 21 12:09:28 EDT 2019 | alexcouto
Hello Bukas, thanks again. Since at an early stage I switched heads # 1 and # 6 and they are not compatible, then I went through the manual and figured out why. in order to start at the beginning and check that it had not damaged anything, I put the
Electronics Forum | Tue Mar 27 17:38:23 EDT 2012 | test_tech
I know it's a little bit crazy, but worst case scenario is I buy a new controller, amps, software, and grudgingly maybe even servo motors. Given the cost of buying an equivalent gantry system new, this certainly is a project worth considering, even
Electronics Forum | Mon Jun 12 21:16:41 EDT 2017 | kahrpr
you can not just take the motor off and change it. the motors have a home pulse singnial. the motor has to be in a certian position the home pulse position when the flag hits the sensor. When you remove the motor you have to mark the motor gear when
Electronics Forum | Thu Jan 19 07:43:54 EST 2023 | bukas
there is a special tool(cable) used to phase the motor with driver.
Electronics Forum | Mon Mar 26 17:09:48 EDT 2012 | test_tech
I have an Eclipse 1, that is no longer in production use for pick and place, but I would like to use the the gantry system and install a custom head to perform other tasks. I am looking for some guidance or information on how the existing servo con
Electronics Forum | Fri Jan 06 09:39:35 EST 2023 | micropak
In newer machines, after changing a motor you have to do an "Axis Home Calibration". Once I changed Z-Axis belt on an SM-482 and it refused to successfully do "Axis Home Calibration. Then the solution was to remove the belt, rotate the motor pulley a
Electronics Forum | Wed Jun 11 16:55:16 EDT 2003 | MA/NY DDave
Hi Yes Thanks, I understand that there are still some arguments going on in the EU and some companies like Phillips AG, I believe, are championing changes. Even so from what I know the combined JEITA/European (Soldertec) /USA NEMI task group is sti
