Electronics Forum | Fri Jun 30 17:38:17 EDT 2006 | grantp
Hi, Thanks guys and that's a big help, as I thought we had to have the lot flushed out, and I guess I must have transferred my worries about us flushing out all parts to our sales channel as well! Regards, Grant
Electronics Forum | Fri May 22 01:34:23 EDT 2009 | isd_jwendell
I have used the Fluke 53 (single channel) and 54 (2 channel) hand-held units. You can get the model 54 for about $300 if you shop around. Is this too much?
Electronics Forum | Mon Aug 31 16:48:16 EDT 2020 | aurash
I wish it was so simple :-) In their wisdom the machine designers choice was to have servo drivers with two channels (one channel less powerful and one channel more powerful) - so each card is driving a X motor and a Y motor.(the X axis is made of 2
Electronics Forum | Thu Jun 02 04:23:44 EDT 2005 | Base
... almost sounds like the Home Shopping channel...
Electronics Forum | Fri Jul 07 10:50:05 EDT 2006 | Rob
I think they come under COSHH regulations as an irritant.
Electronics Forum | Mon Oct 20 18:53:39 EDT 2014 | warwolf
pci express x1? https://www.google.co.nz/search?q=pci+express&client=firefox-a&hs=ZJi&rls=org.mozilla:en-GB:official&channel=sb&source=lnms&tbm=isch&sa=X&ei=DZJFVKvRDaXemAXaxoCgDA&ved=0CAgQ_AUoAQ&biw=1173&bih=849#rls=org.mozilla:en-GB:official&chann
Electronics Forum | Tue Feb 19 16:26:51 EST 2008 | edatasys
Check out http://www.solderstar.com They have 4 , 6 , 9 or 12 channel products. Software is user friendly and contains predefined specs. for solder paste & reflow ovens. Makes setup quick & easy, also has simulation tools to quickly optimize profile
Electronics Forum | Sun May 09 04:18:04 EDT 2004 | Mark Stansfield
Have you taken a look at our SolderStar range of profilers. We offer 4,6 and 12 channel versions. Our 12 channel system can also be connected to our Wave Shuttle product for wave solder machine analysis. Our datalogger are the smallest reflow profile
Electronics Forum | Thu Oct 02 08:24:32 EDT 2008 | rway
If you want to go really cheap, you could try Pace Systems. You can get a three channel system, hot air, desolder and soldering iron. Or any other combination handpieces that they offer, for around $3K. They also have power supplies with a single
Electronics Forum | Wed Sep 15 15:16:29 EDT 2004 | davef
It's going to be tougher to get the recipe correct on his bad dude. [As you'd expect.] But to start with, you need to run a channel of your profile on one of the open balls of this particular heat sinked BGA.
winsouce.jpg)