Electronics Forum | Wed Mar 31 01:14:49 EST 2004 | Peter -CP40
Eric, You should be able to monitor the pressure of your nozzles by selecting: Diagnostics / Vacume check, depending on the type of machine you are running. When you cover the end of the nozzle, you should get a reading of about 500. This means it i
Electronics Forum | Mon Apr 12 04:56:54 EDT 2004 | qualitel
Hi Eric, Every mounter have a standard count and "release" off the component. The sample and cost saving way is to use the paper (e.g: 4mil,5mil...thick) to measure. Just place on the PCB with supoort base below and release the nozzle step by
Electronics Forum | Mon Apr 26 06:09:27 EDT 2004 | Eric
Hi, I'm looking for an equipment which able to check those chip mounter machine placement pressure. Could someone recommend is there an equipment check those pressure during mounting.... Thanks, Eric Chua
Electronics Forum | Mon Apr 26 19:57:18 EDT 2004 | Eric
Hi, I'm using the Fuji CP643 and QP341. Thanks, Eric Chua
Electronics Forum | Wed Apr 28 21:53:35 EDT 2004 | Eric
Hi, Appreciate you could share with me more datail how this is make.....and how you downlaod or monitor the pressure force.... Thanks, Eric Chua
Electronics Forum | Mon Apr 26 18:36:20 EDT 2004 | bilbo baggins
What type of machine? Most placement machines have built-in diagnostics that will tell you...though a maintenance tech may be necessary.
Electronics Forum | Wed Apr 28 10:29:04 EDT 2004 | dougt
By "placement pressure" I assume you mean force. I don't know of placement machines that have transducers mounted on the placement spindles that actually measure force. We made a board with a force sensor mounted through a hole so that it was the sa
Electronics Forum | Thu Apr 29 10:35:31 EDT 2004 | dougt
Start with a load cell (force sensor), you will need one that can handle the force range you will be placing. Someone please correct me on this if I'm wrong but I seem to recall that placement force runs in the range of a couple hundred grams. Chec
Electronics Forum | Fri Mar 25 22:03:30 EDT 2016 | annabella
YANGLING SMT CO.,LIMITED Since 2005, 11 years experience China SMT pick and place parts supplier Paticipate NEPCON Shenzhen(2009-2015) Lots of CM402 nozzles on sale. Any interested in please follow me: Youtube: https://www.youtube.com/watch?v=5vvi80
Electronics Forum | Thu Jun 15 22:17:02 EDT 2006 | Thanagon
I'm now have target to flux saving. Could you please tell me. If we adjust level of spray fluxer nozzle up then we can saving cost of flux Quantity usage? What Others must adjust? such as pressure , flux flow. Thank you All for advise.
